Printer Setup

Connect the Printer to a Power Source

Connect the Printer to a Power Source

Caution • For personnel and equipment safety, always use an approved three-conductor power cord specific to the region or country intended for installation. This cord must use an IEC 320 female connector and the appropriate region-specific three-conductor grounded plug configuration.

To connect the printer to a power source, complete these steps:

1.Turn the printer power switch (located on the rear of the printer) to the Off (O) position.

2.Plug the power cord into the mating connector on the rear of the printer.

3.Plug the other end of the power cord into the power source.

Power Cord Specifications

Depending on how your printer was ordered, a power cord may or may not be included. If one is not included or if the one included is not suitable for your requirements, refer to the following guidelines:

•The overall cord length must be less than 9.8 ft (3.0 m).

•The cord must be rated for at least 5 A, 250 V.

•The chassis ground (earth) must be connected to ensure safety and reduce electromagnetic interference. The third wire in the power cord grounds the connection (Figure 6).

Figure 6 • Power Cord Specifications

1

2

 

 

3

4

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1AC power plug for your country

23-conductor HAR cable

3IEC 320 connector

4Neutral, earth, live in contact view

•The AC power plug and the IEC 320 connector must bear the certification mark of at least one of the known international safety organizations shown in Figure 7.

Figure 7 • International Safety Organization Marks

+

R

23063L-003 Rev. 1 12/6/04

R110Xi/R170Xi User Guide

11