Front Panel Controls
Front Panel LCD
ZebraNet® Wired and Wireless Print Server LCD Displays
The menu options shown in Table 8 display only if you have the ZebraNet PrintServer II, or 10/100 PrintServer, or Wireless Print Server installed.
| Table 8 • Print Server LCD Displays |
|
|
Parameter | Action/Explanation |
|
|
LOAD LAN FROM?1 | This parameter, which serves the same function as the ^NP ZPL command, specifies |
| whether to use the printer’s or the print server’s IP settings at bootup. |
| Accepted Values: PRINTER, PRINTSERVER |
| Default Value: PRINTER |
|
|
WIRED PS | This parameter, which serves the same function as the ^NB ZPL command, tells the |
CHECK?1 | printer whether to search for a wired print server at bootup. |
| Accepted Values: YES, NO |
| Default Value: NO |
|
|
IP PROTOCOL2 | IP Protocol |
| Allows either the user (permanent) or the server (dynamic) to select the IP address. |
| If a dynamic option is chosen, this selection determines the method(s) by which the |
| print server receives the IP address from the server. |
| • Press the right or left oval to display other choices. |
| Default: ALL |
| Selections: ALL, GLEANING ONLY, RARP, BOOTP, DHCP, DHCP AND |
| BOOTP, PERMANENT |
| Note • Use of GLEANING ONLY is not recommended when the Wireless Print |
| Server is installed. |
|
|
IP ADDRESS2 | IP Address |
| This parameter allows you to select the IP address if PERMANENT was chosen in |
| IP PROTOCOL. (If a dynamic option was chosen, the user cannot select the |
| address.) |
| 1. Press the left oval to move to the next digit position. |
| 2. Press the right oval to increase the value of the digit. |
|
|
SUBNET MASK2 | Subnet Mask |
| This parameter selects the part of the IP address that is considered to be part of the |
| local network. It can be reached without going through the default gateway. |
| 1. Press the left oval to move to the next digit position. |
| 2. Press the right oval to increase the value of the digit. |
|
|
1Appears only when the ZebraNet Wireless Print Server is installed.
2These parameters appear after the system recognizes the existence of a ZebraNet print server (wired or wireless). After the print server is recognized, all zeroes (000.000.000.000) will display until the printer obtains an IP address or defaults to address 192.168.254.254.
3If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.
4This parameter appears 1) when no wireless card is inserted or 2) when the wireless card is associated to the WLAN and the card supports LEAP.
60 | R110Xi/R170Xi User Guide |