Color profile: Disabled

Composite Default screen

Continuous Media Loading

Continuous media mounts inside the printer in the same manner as roll me- dia. For proper printer operation, a label length instruction must be included in the label format sent to the printer.

Cutter Mode Media Loading

(Cutter Option Required)

To ensure proper media loading, follow the directions for the Tear-Off Mode with the exception that the media must also be routed through the Cutter Module as shown in Figures 2 and 3.

Close the Printhead Open Lever. The printer will automatically feed out and cut one label when the printer is powered on. Turn to “Transmissive Media Sensor Position Adjustment” on page 15.

Rewind Mode Media Loading

(Rewind Option Required)

NOTE: For best results, install the printer on a level surface. This is especially helpful with wider printers using wide media. If the surface is not level, the media may “telescope” off of the Rewind Spindle, causing unsatisfactory results.

Rewind Mode for Printers Without the Cutter Option

1.Remove the Media Rewind Plate from its storage location in front of the print mechanism inside the media compartment.

2.Invert the Rewind Plate so that the lip on the attached Hook Plate points down.

3.Insert the Hook Plate lip a short distance (½") into the lower opening in the Side Plate.

Zebra XiII-Series User’s Guide

11

23

H:...Xi2UsersGuideR2.vp

Fri Aug 07 10:34:43 1998