Color profile: Disabled

Composite Default screen

Removing the Label Backing Material

(Rewind Option Required)

Since the Backing Rewind Spindle holds the backing from a standard-size media roll, we recommend that you perform this procedure whenever you change the media.

To remove the backing material from the Backing Rewind Spindle, follow these steps (you don’t need to turn the printer power off for this procedure).

1.Unwind about one yard (one meter) of backing from the Backing Rewind Spindle and cut it off at the spindle.

2.Pull out the Spindle Hook and slide the backing material off of the spindle and discard.

3.Wind the media around the Rewind Spindle once or twice and reinstall the Spindle Hook. Continue winding to remove any slack in the media.

Transmissive Media Sensor

Position Adjustment

When the XiII printer is powered on, it performs a self test and configures its operating characteristics. Some of these characteristics are determined by the position of the Transmissive Media Sensor. The factory-set position is sufficient for most types of media. However, if media sensor position adjustments are needed, follow the procedures below.

NOTE: The Reflective (Black-Mark) Media Sensor position is not adjustable; it is positioned to accommodate all black-mark media that meets the specifications listed in “Media Specifications” on page 81.

NOTE: If you are using continuous media (no gap, notch, or hole between labels) or black-mark media, position the transmissive sensor over the media so that the printer can detect an out-of-paper condition. The factory-set position should be sufficient for this purpose.

Zebra XiII-Series User’s Guide

15

27

H:...Xi2UsersGuideR2.vp

Fri Aug 07 10:34:43 1998