Color profile: Disabled
Composite Default screen
4.Align the upper end of the Rewind Plate with the corresponding open- ing in the Side Plate and slide the Rewind Plate in so that it stops against the printer’s main frame.
5.Load the media as described in the instructions for Roll Media Loading on page 9. When loading the media, allow about one yard of media to extend past the
6.Remove the Spindle Hook from the Rewind Spindle. If you are using a core, remove all tape from the core and slide it onto the Rewind Spindle until it is flush against the guide plate.
7.Route the media as shown in Figures 1 and 2 and wind it once or twice around either (1) the Rewind Spindle and reinstall the Hook, or (2) a 3" core. (With some media, especially tag stock, you may need to tape the end of the media to the core if it will not otherwise tighten onto the core. DO NOT tape the label stock unless absolutely necessary.)
NOTE: Before closing the Printhead Open Lever, make sure that the following guidelines are met:
the media is positioned against the inside guides, and the outer guide and Media Supply Guide barely touch the media
the media is taut
the media is parallel with itself and with the pathway when wound on the Rewind Spindle/core
8.Media loading is now complete. See “Transmissive Media Sensor Position Adjustment” on page 15.
Rewind Mode for Printers With the Cutter Option
1.Remove the Media Rewind Plate from its storage location in front of the print mechanism inside the media compartment.
2.Invert the Rewind Plate so that the lip on the attached Hook Plate points down.
12 | Zebra |
24
H:...Xi2UsersGuideR2.vp
Fri Aug 07 10:34:43 1998