Color profile: Disabled

Composite Default screen

Leaving the Program Mode

You can leave the Program Mode at any time by pressing the Setup/Exit key. The SAVE CHANGES display will appear. There are five choices, described below. Pressing the left or right black oval key displays other choices and pressing the Next/Save key selects the displayed choice.

￿PERMANENT - permanently saves the changes. Values are stored in the printer even when power is turned off.

￿TEMPORARY - saves the changes until changed again or until power is turned off.

￿CANCEL - cancels all changes since pressing the Setup/Exit key except the Darkness and Tear-Off settings (if they were changed).

￿LOAD DEFAULTS - loads factory defaults. The factory defaults are shown on the following pages.

NOTE: Loading factory defaults will require ptinter calibration and resetting the Head Resistor value.

￿LOAD LAST SAVE - loads values from the last Permanent Save.

Zebra XiII-Series User’s Guide

31

43

H:...Xi2UsersGuideR2.vp

Fri Aug 07 10:35:48 1998