Color profile: Disabled

Composite Default screen

The Transmissive Media Sensor consists of two sections. The media passes between a light source (Lower Media Sensor) and a light sensor (Upper Media Sensor).

This adjustment aligns the position of the Upper and Lower Media Sensors with the notch or edge of the label.

UPPER

MEDIA SENSOR

ADJUSTMENT

Figure 4. Upper Media Sensor AdjustmentAdjusting the Upper Media Sensor Position

NOTE: If you own a 140XiII or 170XiII printer and need to move the sensor to the outside half of the maximum media width, or from the outside half to the inside half, contact a service technician to perform this procedure because it will require additional steps which are beyong the scope of this user’s guide.

To adjust the upper media sensor, follow these steps.

1. Remove ribbon if it is installed.

16

Zebra XiII-Series User’s Guide

28

H:...Xi2UsersGuideR2.vp

Fri Aug 07 10:34:44 1998