Color profile: Disabled

Composite Default screen

3.Insert the Hook Plate lip a short distance (½") into the lower opening in the Side Plate and slide the Rewind Plate in so that it stops against the printer’s main frame.

4.Insert the two small tabs on the Rewind Plate into the corresponding slots in the Cutter Support Bracket. (The Rewind Plate should spring into the proper position.)

5.Load the media as described in the instructions for Roll Media Loading on page 9. When loading the media, allow about one yard of media to extend past the Tear-Off bar. If using label stock remove all labels from this portion of the media to create a leader.

6.Remove the Hook from the Rewind Spindle. If you are using a core, re- move all tape from the core and slide it onto the Rewind Spindle until it is flush against the guide plate.

7.Route the media as shown in Figures 1 and 2 and wind it once or twice around either (1) the Rewind Spindle and reinstall the Hook, or (2) a 3" core. (With some media, especially tag stock, you may need to tape the end of the media to the core if it will not otherwise tighten onto the core. DO NOT tape the label stock unless absolutely necessary.)

NOTE: Before closing the Printhead Open Lever, make sure that the following guidelines are met:

￿the media is positioned against the inside guides, and the outer guide and Media Supply Guide barely touch the media

￿the media is taut

￿the media is parallel with itself and with the pathway when wound on the Rewind Spindle/core

8.Media loading is now complete. See “Transmissive Media Sensor Position Adjustment” on page 15.

Zebra XiII-Series User’s Guide

13

25

H:...Xi2UsersGuideR2.vp

Fri Aug 07 10:34:43 1998