ZyAIR 100 Wireless PC Card
Signal Level
The signal level when receiving the last test packet. The signal level is calculated as the percentage of its signal level measurement relative to the full signal level.
•Loopback Through the Access Point (Infrastructure Network Type)
If you use the Infrastructure wireless LAN configuration (network type), you may select the Access Point loopback test to verify the communication quality between your wireless station and Access Point. To run the loopback test, select the Loopback through the access point option and click on the Start button. Note that it only works in the Infrastructure mode.
Figure 4-9 Diagnostic Tools – Link Quality Test (Loopback Through Access Point)
The following table explains the status/statistical information found in the Loopback Through Access Point screen.
Parameter Configuration |
