
Prestige
13.4 Internet Access Configuration
Menu 4 allows you to enter the Internet Access information in one screen. Menu 4 is actually a simplified setup for one of the remote nodes that you can access in menu 11. Before you configure your Prestige for Internet access, you need to collect your Internet account information.
Use the Internet Access Checklist table in the Read Me First to record your Internet account information. Note that if you are using PPPoA or PPPoE encapsulation, then the only ISP information you need is a login name and password. You only need to know the Ethernet Encapsulation Gateway IP address if you are using ENET ENCAP encapsulation.
From the main menu, type 4 to display Menu 4 - Internet Access Setup, as shown next.
Menu 4 - Internet Access Setup
ISP's Name= MyISP
Encapsulation= PPPoE
Multiplexing=
VPI #= 1
VCI #= 32
ATM QoS Type= CBR
Peak Cell Rate (PCR)= 0
Sustain Cell Rate (SCR)= 0
Maximum Burst Size (MBS)= 0
My Login= N/A
My Password= N/A
ENET ENCAP Gateway= 0.0.0.0
IP Address Assignment= Static
IP Address= 0.0.0.0
Network Address Translation= SUA Only
Address Mapping Set= N/A
Press ENTER to Confirm or ESC to Cancel:
FigureThe following table contains instructions on how to configure your Prestige for Internet access.
TableFIELD | DESCRIPTION | EXAMPLE |
|
|
|
ISP’s Name | Enter the name of your Internet Service Provider. This | MyISP |
| information is for identification purposes only. |
|
Encapsulation | Press [SPACE BAR] to select the method of encapsulation | PPPoE |
| used by your ISP. Choices are PPPoE and RFC 1483. |
|
Internet Access |