Figure 117 wrr Command Example
ras# configure ras(config)# wrr ras(config)# wrr 4 3 2 1
28.10 interface Commands
These are some commonly used commands that belong to the interface group of commands.
28.10.1 interface port-channel
Syntax:
interface
Use this command to enable the specified ports for configuration. Type multiple ports or port ranges separated by a comma. Ranges of port numbers are typed separated by a dash.
An example is shown next.
•Enter the configuration mode.
•Enable ports one, three, four and five for configuration.
•Begin configuring for those ports.
Figure 118 interface Command Example
ras# config
ras(config)# interface
28.10.2 bmstorm-limit
Syntax:
| |
| |
where |
|
| Enables broadcast storm control limit on the switch. |
<Kbps> | Limits broadcast packet traffic the interface receives per second. |
Chapter 28 Command Examples | 175 |