LABEL | DESCRIPTION |
|
|
System up Time | This field shows how long the system has been running since the last time it was |
| started. |
Port | This identifies the Ethernet port. Click a port number to display the Port Details |
| screen (refer to Figure 25 on page 53). |
Link | This field displays the speed (either 10M for 10Mbps, 100M for 100Mbps or another |
| value depending on the uplink module being used) and the duplex (F for full duplex |
| or H for half duplex). |
State | This field displays the STP (Spanning Tree Protocol) state of the port. See the |
| chapter on STP for details on STP states. |
LACP | This fields displays whether LACP (Link Aggregation Control Protocol) has been |
| enabled on the port. |
TxPkts | This field shows the number of transmitted frames on this port. |
|
|
RxPkts | This field shows the number of received frames on this port. |
|
|
Errors | This field shows the number of received errors on this port. |
|
|
Tx KB/s | This field shows the number of kilobytes per second transmitted on this port. |
|
|
Rx KB/s | This field shows the number of kilobytes per second received on this port. |
|
|
Up Time | This field shows the total amount of time in hours, minutes and seconds the port has |
| been up. |
Poll Interval(s) | The text box displays how often (in seconds) this screen refreshes. You may change |
| the refresh interval by typing a new number in the text box and then clicking Set |
| Interval. |
Stop | Click Stop to halt system statistic polling. |
|
|
Clear Counter | Select a port from the Port |
| the recorded statistical information for that port. |
6.2.1 Status: Port Details
Click a number in the Port column in the Status screen to display individual port statistics. Use this screen to check status and detailed performance data about an individual port on the switch.
52 | Chapter 6 System Status and Port Statistics |