Chapter 8 Access Point Mode
NBG-419N User’s Guide 73
8.3.2 Accessing the Web Configurator in Access Point Mode
Log in to the Web Configurator in Access Point mode, do the following:
1Connect your computer to the LAN port of the NBG-419N.
2The default IP address of the NBG-419N is “192.168.1.2”. In this case, your
computer must have an IP address in the range between “192.168.1.3” and
“192.168.1.254”.
3Click Start > Run on your computer in Windows. Type “cmd” in the dialog box.
Enter “ipconfig” to show your computer’s IP address. If your computer’s IP
address is not in the correct range then see Appendix C on page 251 for
information on changing your computer’s IP address.
4After you’ve set your computer’s IP address, open a web browser such as Internet
Explorer and type “192.168.1.2” as the web address in your web browser.

Note: After clicking Login, the Easy mode appears. Refer to Section on page 51 for

the Easy mode screens. Change to Expert mode to see the screens described

in the sections following this.

8.3.3 Configuring your WLAN, Bandwidth Management and Maintenance Settings
The configuration of wireless, bandwidth management and maintenance settings
in Access Point mode is the same as for Router Mode.
• See Chapter 11 on page 99 for information on the configuring your wireless
network.
• See Chapter 21 on page 173 for information on configuring your Bandwidth
Management screen.
• See Maintenance and Troubleshooting (195) for information on config uring
your Maintenance settings.