Chapter 12 WAN
NBG-419N User’s Guide
132
12.5 Advanced WAN Screen
Use this screen to enable Multicast and enable Auto-bridge.

Note: The categories shown in this screen are independent of each other.

To change your NBG-419N’s advanced WAN settings, click Network > WAN >
Advanced. The screen appears as shown.

Figure 84 Network > WAN > Advanced

The following table describes the labels in this screen.
12.6 IGMP Snooping Screen
Use this screen to enable IGMP snooping if you have LAN users that subscribe to
multicast services.

Table 51 Network > WAN > Advanced

LABEL DESCRIPTION
Multicast Setup
Multicast Select IGMPv1/v2 to enable multicasting. This applies to traffic
routed from the WAN to the LAN.
Select None to disable this feature. This may cause incoming traffic
to be dropped or sent to all connected network devices.
Auto-bridge
Enable Auto-bridge
mode
Select this option to have the NBG-419N switch to bridge mode
automatically when the NBG-419N gets a WAN IP address in the
range of 192.168.x.y (where x and y are from zero to nine) no
matter what the LAN IP address is.
Apply Click Apply to save your changes back to the NBG-419N.
Reset Click Reset to begin configuring this screen afresh.