Chapter 17 Remote Management Configuration
The following table describes the labels in this screen.
Table 88 Remote Management: WWW
LABEL | DESCRIPTION |
Port | You may change the server port number for a service if needed, however you must |
| use the same port number in order to use that service for remote management. |
|
|
Access Status | Select the interface(s) through which a computer may access the ZyXEL Device |
| using this service. |
|
|
Secured Client IP | A secured client is a “trusted” computer that is allowed to communicate with the |
| ZyXEL Device using this service. |
| Select All to allow any computer to access the ZyXEL Device using this service. |
| Choose Selected to just allow the computer with the IP address that you specify to |
| access the ZyXEL Device using this service. |
|
|
Apply | Click Apply to save your settings to the ZyXEL Device. |
|
|
Cancel | Click Cancel to begin configuring this screen afresh. |
|
|
17.3 Telnet
You can configure your ZyXEL Device for remote Telnet access as shown next. The administrator uses Telnet from a computer on a remote network to access the ZyXEL Device.
Figure 137 Telnet Configuration on a TCP/IP Network
17.4 Configuring Telnet
Click Advanced > Remote MGMT > Telnet tab to display the screen as shown.
| 223 |
|
|