ZyXEL Communications P-6600HW-Tx v3 manual 86

Chapter 5 Wizard Setup for Internet Access

Table 27 Wireless LAN Setup Wizard 2

LABEL	DESCRIPTION
Security	Select Manually assign a WPA-PSK key to configure a pre-shared key (WPA-PSK).
	Choose this option only if your wireless clients support WPA. See Section 5.3.1 on
	page 86 for more information.
	Select Manually assign a WEP key to configure a WEP Key. See Section 5.3.2 on
	page 87 for more information.
	Select Disable wireless security to have no wireless LAN security configured and
	your network is accessible to any wireless networking device that is within range.
Back	Click Back to display the previous screen.
Next	Click Next to proceed to the next screen.
Exit	Click Exit to close the wizard screen without saving.

"The wireless stations and ZyXEL Device must use the same SSID, channel ID and WEP encryption key (if WEP is enabled), WPA-PSK (if WPA-PSK is enabled) for wireless communication.

4This screen varies depending on the security mode you selected in the previous screen. Fill in the field (if available) and click Next.

5.3.1Manually assign a WPA-PSK key

Choose Manually assign a WPA-PSK key in the Wireless LAN setup screen to set up a Pre- Shared Key.

Figure 57 Manually assign a WPA-PSK key

The following table describes the labels in this screen.

Table 28 Manually assign a WPA key

LABEL	DESCRIPTION
Pre-Shared	Type from 8 to 63 case-sensitive ASCII characters. You can set up the most secure
Key	wireless connection by configuring WPA in the wireless LAN screens. You need to
	configure an authentication server to do this.
Back	Click Back to display the previous screen.

86
	P-660HW-Tx v3 User’s Guide