Chapter 2 Introducing the Web Configurator

2.3 Resetting the ZyXEL Device

If you forget your password or cannot access the web configurator, you will need to use the RESET button at the back of the ZyXEL Device to reload the factory-default configuration file. This means that you will lose all configurations that you had previously and the password will be reset to “1234”.

2.3.1 Using the Reset Button

1Make sure the POWER LED is on (not blinking).

2Press the RESET button for ten seconds or until the POWER LED begins to blink and then release it. When the POWER LED begins to blink, the defaults have been restored and the ZyXEL Device restarts.

2.4Navigating the Web Configurator

2.4.1 Navigation Panel

After you enter the admin password, use the sub-menus on the navigation panel to configure ZyXEL Device features. The following table describes the sub-menus.

Figure 11 Web Configurator: Main Screen

Click the Logout icon at any time to exit the web configurator.

Use the submenus to configure ZyXEL Device features.

48

 

P-660HW-Tx v3 User’s Guide