Appendix E Command Interpreter
Configuring What You Want the ZyXEL Device to Log
1Use the sys logs load command to load the log setting buffer that allows you to configure which logs the ZyXEL Device is to record.
2Use sys logs category to view a list of the log categories.
Figure 238 Displaying Log Categories Example
ras> sys logs category | attack | display | |
8021x | access | ||
error | icmp | ike | ipsec |
javablocked | mten | packetfilter | ppp |
cdr | pki | tls | remote |
tcpreset | traffic | upnp | urlblocked |
urlforward | wireless |
|
|
3Use sys logs category followed by a log category to display the parameters that are available for the category.
Figure 239 Displaying Log Parameters Example
ras> sys logs category access
Usage: [0:none/1:log/2:alert/3:both] [0:don't show debug type/1:show debug type]
4Use sys logs category followed by a log category and a parameter to decide what to record.
Use 0 to not record logs for that category, 1 to record only logs for that category, 2 to record only alerts for that category, and 3 to record both logs and alerts for that category. Not every parameter is available with every category.
5Use the sys logs save command to store the settings in the ZyXEL Device (you must do this in order to record logs).
Displaying Logs
•Use the sys logs display command to show all of the logs in the ZyXEL Device’s log.
•Use the sys logs category display command to show the log settings for all of the log categories.
•Use the sys logs display [log category] command to show the logs in an individual ZyXEL Device log category.
•Use the sys logs clear command to erase all of the ZyXEL Device’s logs.
350 |
| |
| ||
|
|
|