Sony AV-DV75 manual Aboijtthe Remote Control, Press one of the buttons indicated above

ABOIJTTHE REMOTE CONTROL

Inserting batteries

Detach the battery cover on the rear of the remote control and insert two R6(size AA) batteries.

R6(AA)

When to replace the batteries

The maximum operational distance between the remote control and the sensor on the unit should be approximately 5 meters (16 feet). When this distance decreases, replace the batteries with new ones.

Using the remote control

The instructions in this manual refer mainly to the buttons on the main unit. In principle buttons on the remote control with the same names as those on the main unit can be used as well.

mm

●If the unit is not going to be used for an extended period of time, remove the batteries to prevent possible electrolyte leakage.

●The remote control may not operate correctly when:

-The line of sight between the remote control and the remote sensor in the display window is exposed to intense light, such as direct sunlight.

-Other remote controls are used nearby (those of a television, etc.)

Remote control operation

This remote control system allows you to operate other external equipment besides the AIWA receiver. For details c~fthe remote control operation for other external equipment, see “REMOTE CONTROL” on page 19.

The following is an explanation on how to operate the Aiwi~ receiver,

		RECEIVER/DIGIT
AIWA
RECEIVER –		SET UP
MUTE –
POWER –		TUNER PRESET/
		SURROUND
FUNCTION –+J	~+	VOLUME

1 Press the AIWA RECEIVER button to set the remote control to the Aiwa receiver mode.

2 Press one of the buttons indicated above.

FUNCTION button

Each time this butlton is pressed, the sound source changes cyclically.

TUNER PRESET/SURROUND buttons

Tune in the station which has been preset on the receiver.

To go to a higher preset number, press the UP-II button. To go to a lower preset number, press the DOWN K< button. This button is also used when adjusting the speaker level balance of the DSP, Dolby Pro Logic or Dolby Digital Surround mode.

EmE!

It is not necessary to press the AIWA RECEIVER button each time you operate the Aiwa receiver unless another mode has already been set. (See “REMOTECONTROL” on page 19.)

If the receiver cannot be operated with the remote control

Follow the steps below using the remote control.

1 Press the AIWA RECEIVER button.

2 Press and hold the SET UP button for about 2.5 seconds.

The indicator on the top of the remote control blinks twits while pressing the button.

3 Press the DIGIT buttons in the order of “4:’ “O” and “6.”

IENGLI$H (’)