Husqvarna DT22 manual Fuel system

Page 12

SAFETY INSTRUCTIONS

Fuel system

WARNING!

Gasoline and gasoline fumes are poisonous and extremely flammable. Be especially careful when handling gasoline, as carelessness can result in personal injury or fire.

Only store fuel in containers approved for that purpose.

Never remove the fuel cap and fill the fuel tank when the engine is running.

Always stop the engine when refueling.

Do not smoke when filling the gasoline tank and do not pour gasoline in the vicinity of sparks or open flame.

Never fill the fuel tank indoors.

Before starting the machine after refueling, it should be moved at least 10 feet (3 M) from the location where it was filled.

Turn off the fuel supply for storage or transport.

If leaks arise in the fuel system, the engine must not be started until the problem has been resolved.

Check the fuel level before each use and leave space for the fuel to expand, because the heat from the engine and the sun can otherwise cause the fuel to expand and overflow.

Avoid overfilling. If you spill gasoline on the machine, wipe up the spill and wait until it has evaporated before starting the engine. If you spill gasoline on your clothing, change your clothing.

8011-037

Never fill the fuel tank indoors.

8011-036

Close the fuel valve.

8011-019

Fueling always poses an element of risk.

12

Image 12
Contents DT22 Table of Contents Introduction Symbols and Decals Decals and machine-bound instructionsLocation of decals Decal Seed application chart Translation of instructionsSafety Instructions General useSafety Instructions Preparations Running Movement/Transport StorageChildren Fuel system Maintenance Presentation PresentationMain components and operating instruments Engine Throttle controlStarter Starter handleFuel valve ChokeSpark plug MufflerOil dipstick Oil drainageFuel tank FuelingCutting unit Depth lever Depth knobDepth lock ClutchSetting blade height Blade versatilityFlail blade Delta bladeOperation Starting the engineCutting the engine Before you start StartingFinishing Maintenance Maintenance scheduleReplacing the air filter Cleaning the sludge reservoir Idle adjustmentIgnition system Fitting the wrong spark plug type can damage the engineCutting unit Checking the drive beltReplacing the drive belt Wear/Rotation/Replacing flail blades When tipping the machine forward observe the Two minute rule Replacing worn flail bladesWear/Replacing delta blades Screws Delta BladeNuts Wear/Replacing spring tines Spring Tine ScrewCleaning and washing Two minute ruleLubrication Lubrication scheduleGeneral Engine oil Checking the engine’s oil levelDepth knob with depth lock BladesDepth lever HandleTroubleshooting Symptom Cause Engine will not startService StorageWinter storage Technical Data Specifications DT22Assembly Instructions Assembly delivery serviceBagger Assembly Assembly directions, catcher bagAttach the chute to the mainframe Extender Wire tie the cable to the handle. See Correct height setting Instructions for the catcher bagCollection conditions Seeder Assembly Do not use or start the engine until the seeder is in placeRe-attach rubber flap rod with push nut to Seed Gate Cable Clamp Adjusting the seed hopper Instructions for the seederService Journal Delivery serviceAfter the first 20 hours Sound Test Vibraton LevelPage Page ´z+H3J¶6T¨ Page 114 01 2003W10