Husqvarna DT22 manual Seed Gate Cable Clamp

Page 48

SEEDER ASSEMBLY

20.Attach the cable with a wire tie farther up the handle.

21.Check adjustment of the cable by tipping unit forward confirming that when the control le- ver is in the closed position the seedgate is fully closed.

If the seedgate needs adjusting, loosen the screw and nut holding the cable clamp. Move the cable back or forward in the clamp until the seedgate is fully closed when the control lever is in the closed postion. DO NOT move the seedgate with your hand, use the cable to move the seedgate for a more accurate ad- justment.

22.To check the seed dial adjustment , insert a 1/8" drill bit into one of the holes in the seed gate, the seed dial should read 3 1/2. If not, adjust the cable by loosening the screw and nut holding the cable clamp. Move the cable back or forward in the clamp until the seed dial reads 3 1/2.

SEED GATE	CABLE CLAMP
	DT25

FIGURE 7

23.Make sure the cable moves freely. NEVER kink the cable.

24.Re-check the unit to see if it functions properly.

48

Image 48

Contents DT22 Table of Contents Introduction Symbols and Decals Decals and machine-bound instructionsLocation of decals Decal Seed application chart Translation of instructionsSafety Instructions General useSafety Instructions Preparations Running Movement/Transport StorageChildren Fuel system Maintenance Presentation PresentationMain components and operating instruments Engine Throttle controlStarter Starter handleFuel valve ChokeSpark plug MufflerOil dipstick Oil drainageFuel tank FuelingCutting unit Depth lever Depth knobDepth lock ClutchSetting blade height Blade versatilityFlail blade Delta bladeOperation Starting the engineCutting the engine Before you start StartingFinishing Maintenance Maintenance scheduleReplacing the air filter Cleaning the sludge reservoir Idle adjustmentIgnition system Fitting the wrong spark plug type can damage the engineCutting unit Checking the drive beltReplacing the drive belt Wear/Rotation/Replacing flail blades When tipping the machine forward observe the Two minute rule Replacing worn flail bladesWear/Replacing delta blades Screws Delta BladeNuts Wear/Replacing spring tines Spring Tine ScrewCleaning and washing Two minute ruleLubrication Lubrication scheduleGeneral Engine oil Checking the engine’s oil levelDepth knob with depth lock BladesDepth lever HandleTroubleshooting Symptom Cause Engine will not startService StorageWinter storage Technical Data Specifications DT22Assembly Instructions Assembly delivery serviceBagger Assembly Assembly directions, catcher bagAttach the chute to the mainframe Extender Wire tie the cable to the handle. See Correct height setting Instructions for the catcher bagCollection conditions Seeder Assembly Do not use or start the engine until the seeder is in placeRe-attach rubber flap rod with push nut to Seed Gate Cable Clamp Adjusting the seed hopper Instructions for the seederService Journal Delivery serviceAfter the first 20 hours Sound Test Vibraton LevelPage Page ´z+H3J¶6T¨ Page 114 01 2003W10