Husqvarna DT22 manual Fuel tank, Fueling

Page 19

PRESENTATION

Fuel tank

Underneath the tank, there is a fuel filter combined with the fuel valve. The tank can be filled with 3.6 liters/0.95 US Gal for the DT22.

Fueling

Read the safety instructions before fueling. Keep the fuel and fuel tank clean. Avoid filling the machine with dirty fuel. Make sure the fuel cap is properly tightened and the gasket is not damaged, particularly before washing the machine.

Use unleaded gasoline with minimum 86 octane rating. Never use gasoline mixed with two-cycle oil. For ethanol and methanol fuel, the following applies:

Maximum allowable ethanol 10% (volume).

Maximum allowable methanol 5% (volume).

Maximum allowable MTBE (Methyl Tertiary Butyl Ether) 15% (volume).

If the engine ”bolts” at normal load it can be damaged. Change the fuel. If this does not help, contact an authorized service workshop.

Do not fill the tank completely; leave space for the fuel to expand as it warms up.

8011-019

WARNING!

Gasoline is highly flammable. Observe caution and fill the tank outdoors.

(See the safety instructions.)

19

Image 19

Contents DT22 Table of Contents Introduction Decals and machine-bound instructions Symbols and DecalsLocation of decals Translation of instructions Decal Seed application chartGeneral use Safety InstructionsSafety Instructions Preparations Running Storage Movement/TransportChildren Fuel system Maintenance Presentation PresentationMain components and operating instruments Throttle control EngineChoke StarterStarter handle Fuel valveOil drainage Spark plugMuffler Oil dipstickFueling Fuel tankClutch Cutting unit Depth leverDepth knob Depth lockDelta blade Setting blade heightBlade versatility Flail bladeStarting the engine OperationCutting the engine Starting Before you startFinishing Maintenance schedule MaintenanceReplacing the air filter Idle adjustment Cleaning the sludge reservoirFitting the wrong spark plug type can damage the engine Ignition systemChecking the drive belt Cutting unitReplacing the drive belt Wear/Rotation/Replacing flail blades Replacing worn flail blades When tipping the machine forward observe the Two minute ruleSpring Tine Screw Wear/Replacing delta bladesScrews Delta Blade Nuts Wear/Replacing spring tinesTwo minute rule Cleaning and washingLubrication schedule LubricationGeneral Checking the engine’s oil level Engine oilHandle Depth knob with depth lockBlades Depth leverSymptom Cause Engine will not start TroubleshootingStorage ServiceWinter storage Specifications DT22 Technical DataAssembly delivery service Assembly InstructionsAssembly directions, catcher bag Bagger AssemblyAttach the chute to the mainframe Extender Wire tie the cable to the handle. See Instructions for the catcher bag Correct height settingCollection conditions Do not use or start the engine until the seeder is in place Seeder AssemblyRe-attach rubber flap rod with push nut to Seed Gate Cable Clamp Instructions for the seeder Adjusting the seed hopperDelivery service Service JournalAfter the first 20 hours Vibraton Level Sound TestPage Page ´z+H3J¶6T¨ Page 2003W10 114 01