Husqvarna DT22 manual Assembly Instructions, Assembly delivery service

Page 40

ASSEMBLY INSTRUCTIONS

Assembly – delivery service

1.Rotate the handle and tighten it in place.

2.Fill the engine with the manufacturer-recommended oil. See section ”Lubrication/Engine oil”.

3.Test the clutch. Make sure that the clutch expansion spring disengages easily.

4.The engine RPM is preset by the manufacturer. Idle speed is 1250–1400 RPM. Maximum engine speed is 3600 RPM.

See the engine manual for instructions on adjusting the regulator and carburetor if the engine speed is not within these limits.

1

3

4

2

DT03

1.Handle

2.Oil refill engine

3.Clutch cable

4.Clutch bail

40

Image 40

Contents DT22 Table of Contents Introduction Symbols and Decals Decals and machine-bound instructionsLocation of decals Decal Seed application chart Translation of instructionsSafety Instructions General useSafety Instructions Preparations Running Storage Movement/TransportChildren Fuel system Maintenance Presentation PresentationMain components and operating instruments Engine Throttle controlStarter Starter handleFuel valve ChokeSpark plug MufflerOil dipstick Oil drainageFuel tank FuelingCutting unit Depth lever Depth knobDepth lock ClutchSetting blade height Blade versatilityFlail blade Delta bladeOperation Starting the engineCutting the engine Starting Before you startFinishing Maintenance Maintenance scheduleReplacing the air filter Cleaning the sludge reservoir Idle adjustmentIgnition system Fitting the wrong spark plug type can damage the engineChecking the drive belt Cutting unitReplacing the drive belt Wear/Rotation/Replacing flail blades When tipping the machine forward observe the Two minute rule Replacing worn flail bladesWear/Replacing delta blades Screws Delta BladeNuts Wear/Replacing spring tines Spring Tine ScrewCleaning and washing Two minute ruleLubrication schedule LubricationGeneral Engine oil Checking the engine’s oil levelDepth knob with depth lock BladesDepth lever HandleTroubleshooting Symptom Cause Engine will not startStorage ServiceWinter storage Technical Data Specifications DT22Assembly Instructions Assembly delivery serviceBagger Assembly Assembly directions, catcher bagAttach the chute to the mainframe Extender Wire tie the cable to the handle. See Instructions for the catcher bag Correct height settingCollection conditions Seeder Assembly Do not use or start the engine until the seeder is in placeRe-attach rubber flap rod with push nut to Seed Gate Cable Clamp Adjusting the seed hopper Instructions for the seederDelivery service Service JournalAfter the first 20 hours Sound Test Vibraton LevelPage Page ´z+H3J¶6T¨ Page 114 01 2003W10