Husqvarna DT22 manual Operation, Starting the engine

Page 22

OPERATION

Starting the engine

Check that all daily maintenance as described in the maintenance schedule has been performed. Check that there is sufficient fuel in the tank.

Fuel valve

Open the fuel valve. Turn the lever all the way to the right.

Choke

When starting the engine warm, the lever should be in the right position; see the illustration.

When starting the engine cold or partially warm, turn the lever completely or partly to the left.

Move the lever back to the right once the engine starts. When the engine is cold, it may be best to move the lever back in several stages. Find the position where the engine runs smoothly.

Throttle control

Set the throttle with about 1/3 of full throttle from idle. This means 1/3 of the way from the rightmost end stop.

Engine switch

Turn the engine switch clockwise to ON.

OFF

ON

8011-072

8011-035

8011-034

8011-071

22

Image 22
Contents DT22 Table of Contents Introduction Symbols and Decals Decals and machine-bound instructionsLocation of decals Decal Seed application chart Translation of instructionsSafety Instructions General useSafety Instructions Preparations Running Storage Movement/TransportChildren Fuel system Maintenance Presentation PresentationMain components and operating instruments Engine Throttle controlFuel valve StarterStarter handle ChokeOil dipstick Spark plugMuffler Oil drainageFuel tank FuelingDepth lock Cutting unit Depth leverDepth knob ClutchFlail blade Setting blade heightBlade versatility Delta bladeOperation Starting the engineCutting the engine Starting Before you startFinishing Maintenance Maintenance scheduleReplacing the air filter Cleaning the sludge reservoir Idle adjustmentIgnition system Fitting the wrong spark plug type can damage the engineChecking the drive belt Cutting unitReplacing the drive belt Wear/Rotation/Replacing flail blades When tipping the machine forward observe the Two minute rule Replacing worn flail bladesNuts Wear/Replacing spring tines Wear/Replacing delta bladesScrews Delta Blade Spring Tine ScrewCleaning and washing Two minute ruleLubrication schedule LubricationGeneral Engine oil Checking the engine’s oil levelDepth lever Depth knob with depth lockBlades HandleTroubleshooting Symptom Cause Engine will not startStorage ServiceWinter storage Technical Data Specifications DT22Assembly Instructions Assembly delivery serviceBagger Assembly Assembly directions, catcher bagAttach the chute to the mainframe Extender Wire tie the cable to the handle. See Instructions for the catcher bag Correct height settingCollection conditions Seeder Assembly Do not use or start the engine until the seeder is in placeRe-attach rubber flap rod with push nut to Seed Gate Cable Clamp Adjusting the seed hopper Instructions for the seederDelivery service Service JournalAfter the first 20 hours Sound Test Vibraton LevelPage Page ´z+H3J¶6T¨ Page 114 01 2003W10