Husqvarna DT22 manual Extender

Page 43

BAGGER ASSEMBLY

EXTENDER

LANYARD

PIN

DT13

FIGURE 6

EXTENDER

SPRING

LOWER HANDLE

UPPER BOLT

DT15

FIGURE 8

18.Place door in position and set the hinge bolts. DO NOT tighten the bolts, leave at least 1/16" space. Thread nut on to the bolt. See Figure

BOLT

NUT

DT14

FIGURE 7

20.Attach upper handle to the extenders.

21.Attach upper end of cable to the handle and install cable through clutch bail. Fit clutch bail into the handle. See Figure 9.

DT16

FIGURE 9

19.Remove upper bolt from lower handle and rotate handle toward the ground. Using the hardware provided install the spring to the extender. Rotate handle back to original position stretching spring, re-install the 3/8" bolt into the lower handle. Repeat on other side. See Figure 8.

43

Image 43

Contents DT22 Table of Contents Introduction Decals and machine-bound instructions Symbols and DecalsLocation of decals Translation of instructions Decal Seed application chartGeneral use Safety InstructionsSafety Instructions Preparations Running Storage Movement/TransportChildren Fuel system Maintenance Presentation PresentationMain components and operating instruments Throttle control EngineChoke StarterStarter handle Fuel valveOil drainage Spark plugMuffler Oil dipstickFueling Fuel tankClutch Cutting unit Depth leverDepth knob Depth lockDelta blade Setting blade heightBlade versatility Flail bladeStarting the engine OperationCutting the engine Starting Before you startFinishing Maintenance schedule MaintenanceReplacing the air filter Idle adjustment Cleaning the sludge reservoirFitting the wrong spark plug type can damage the engine Ignition systemChecking the drive belt Cutting unitReplacing the drive belt Wear/Rotation/Replacing flail blades Replacing worn flail blades When tipping the machine forward observe the Two minute ruleSpring Tine Screw Wear/Replacing delta bladesScrews Delta Blade Nuts Wear/Replacing spring tinesTwo minute rule Cleaning and washingLubrication schedule LubricationGeneral Checking the engine’s oil level Engine oilHandle Depth knob with depth lockBlades Depth leverSymptom Cause Engine will not start TroubleshootingStorage ServiceWinter storage Specifications DT22 Technical DataAssembly delivery service Assembly InstructionsAssembly directions, catcher bag Bagger AssemblyAttach the chute to the mainframe Extender Wire tie the cable to the handle. See Instructions for the catcher bag Correct height settingCollection conditions Do not use or start the engine until the seeder is in place Seeder AssemblyRe-attach rubber flap rod with push nut to Seed Gate Cable Clamp Instructions for the seeder Adjusting the seed hopperDelivery service Service JournalAfter the first 20 hours Vibraton Level Sound TestPage Page ´z+H3J¶6T¨ Page 2003W10 114 01