Husqvarna DT22 manual Starter handle, Cutting the engine

Page 23

OPERATION

Starter handle

Misuse of the starter handle can damage the starter. Do not twist the starter cord around your hand.

Pull out the handle slowly until the gears mesh. Then give a sharp pull on the starter handle. Do not pull out the starter cord completely and do not let go of the starter handle when extended.

Throttle control

Adjust the engine speed with the throttle. Moving the lever to the left increases throttle and to the right decreases throttle.

8011-044

8011-034

Cutting the engine

If the engine has been running full out, let it run easily for about 30 seconds to 1 minute at low speed.

Engine switch

Turn the engine switch counterclockwise to OFF.

Fuel valve

Close the fuel valve. Turn the lever all the way to the left (see illustration).

OFF

ON

8011-026

8011-036

23

Image 23

Contents DT22 Table of Contents Introduction Decals and machine-bound instructions Symbols and DecalsLocation of decals Translation of instructions Decal Seed application chartGeneral use Safety InstructionsSafety Instructions Preparations Running Children Movement/TransportStorage Fuel system Maintenance Presentation PresentationMain components and operating instruments Throttle control EngineChoke StarterStarter handle Fuel valveOil drainage Spark plugMuffler Oil dipstickFueling Fuel tankClutch Cutting unit Depth leverDepth knob Depth lockDelta blade Setting blade heightBlade versatility Flail bladeStarting the engine OperationCutting the engine Finishing Before you startStarting Maintenance schedule MaintenanceReplacing the air filter Idle adjustment Cleaning the sludge reservoirFitting the wrong spark plug type can damage the engine Ignition systemReplacing the drive belt Cutting unitChecking the drive belt Wear/Rotation/Replacing flail blades Replacing worn flail blades When tipping the machine forward observe the Two minute ruleSpring Tine Screw Wear/Replacing delta bladesScrews Delta Blade Nuts Wear/Replacing spring tinesTwo minute rule Cleaning and washingGeneral LubricationLubrication schedule Checking the engine’s oil level Engine oilHandle Depth knob with depth lockBlades Depth leverSymptom Cause Engine will not start TroubleshootingWinter storage ServiceStorage Specifications DT22 Technical DataAssembly delivery service Assembly InstructionsAssembly directions, catcher bag Bagger AssemblyAttach the chute to the mainframe Extender Wire tie the cable to the handle. See Collection conditions Correct height settingInstructions for the catcher bag Do not use or start the engine until the seeder is in place Seeder AssemblyRe-attach rubber flap rod with push nut to Seed Gate Cable Clamp Instructions for the seeder Adjusting the seed hopperAfter the first 20 hours Service JournalDelivery service Vibraton Level Sound TestPage Page ´z+H3J¶6T¨ Page 2003W10 114 01