Husqvarna DT22 manual Maintenance schedule

MAINTENANCE

Maintenance schedule

The following is a list of maintenance procedures that must be performed on the machine. For those points not described in this manual, visit an authorized service workshop.

		Daily	Maintenance interval months/hours
		maint.
Maintenance	Page
		before	1/25	3/50	6/100	12/300
		starting
Check the engine oil level	34
Replace engine oil 1)	34
Check the air filter	25
Clean the air filter 2)	25
Replace air filter cartridge 2)	25
Clean sludge reservoir for fuel system	26
Check and clean the spark plug	27
Replace the spark plug	27
Check idle speed	26
Check and adjust play in valves 4)	-
Clean fuel tank 4)	-
Check, replace fuel lines as necessary 4, 5)	-
Check clutch and clutch cable	-
Check flail blade lock washers	-
Check decals and warning signs	-
Check the seed holes for the seeder	-
Check wear and tension on the belts	28
Check blade wear and condition	29
Check the chassis, bolts and set screws	-
Check the seed control lever for the seeder	-
Check the wire mountings on the seeder	-
Lubrication; see the Lubrication schedule

1)First change after 20 hours. 2) In dusty conditions maintenance is required at shorter intervals. 3) With daily use, the machine shall be lubricated twice weekly. 4) Performed by authorized service workshop. 5) Performed every second year.

= Described in this manual.

❍= Not described in this manual.

WARNING!

No service operations may be performed on the engine or unit unless:

•The engine is stopped.

•The ignition cable has been removed from the spark plug.

•The machine is securely parked where it will not tip or begin rolling.

25