Husqvarna DT22 manual Replacing the air filter

MAINTENANCE

Replacing the air filter

If the engine seems weak, produces black smoke or runs unevenly, the air filter may be clogged.

For this reason, it is important to clean and replace the air filter regularly (see the maintenance schedule for the proper service interval).

WARNING!

Allow the exhaust system to cool before performing service. Risk for burns.

Cleaning/replacement of the air filter is carried out as follows:

1. Undo the wing nut and lift off the air filter cowling.

2. Remove the foam rubber pre-filter and clean using a mild detergent.

Squeeze it dry with a clean cloth.

Soak it with new engine oil. Wind the filter in an absorbent cloth and squeeze out excess oil.

3. Remove the wing nut in the air filter and remove the paper filter. Tap the paper filter against a fixed surface to remove dust. If the paper filter is still dirty or damaged, it must be replaced.

IMPORTANT INFORMATION

Do not use compressed air over 2 bar/30

PSI to clean the air filter.

Do not wash the paper filter.

Do not oil the paper filter.

4. Refit the air filter as follows:

Mount the paper filter in the air filter housing and tighten the wing nut.

5.Replace the pre-filter on the paper filter.

6.Replace the cowling over the air filter housing.

8011-028

8011-030

8011-031

8011-032

26