SEEDER ASSEMBLY
10.Re-attach rubber flap rod with push nut to
the frame being sure cable is routed above flap rod. See Figure 3. (Some units us cotter pins).
DT21 |
FIGURE 3
11.Using two (2) wire ties attach cable to the frame. See Figure 4.
DT22 |
FIGURE 4
12.Place agitators in the seed box with screw holes toward the center.
13.Make sure locking collar is on the axle then thread the axle though the side of the box and through the agitators in seed box.
14.Rotate axle to line up the holes with the agita- tors holes. Using the
DT23 |
FIGURE 5
15.Center agitators in seed box and tighten bear- ing locking collars. Use punch to tighten the collar then tighten the set screw. Repeat for the other side.
16.Slide wheel on and apply two (2) retaining rings. (Some units use cotter pins instead of retaining rings.)
NOTE: The teeth on the retaining rings should point away from the wheel.
17.Tighten the bearing bolts.
18.Attach the control cable to the inside of the upper handle in the holes provided.
19.Apply ON/OFF decal to the handle. See Figure 6.
CONTROL LEVER
SEED DIAL
OPEN
CLOSED
DT24
FIGURE 6
47