Husqvarna DT22 manual Lubrication schedule, General

Page 34

LUBRICATION

Lubrication schedule

DT22

8011-281

General

Stop the engine and remove the ignition cable before attempting to lubricate the machine.

Unless otherwise specified, when lubricating with grease use Husqvarna’s Universal Grease no. 5310038-01 or Husqvarna’s Lubrication Grease UL 21 no. 5310060-74.

Wipe away excessive grease after lubrication.

It is important to avoid getting lubricant on the belt or the drive surfaces on the belt pulleys. Should this happen, attempt to clean them with spirits. If the belt continues to slip after cleaning, it must be replaced.

34

Image 34

Contents DT22 Table of Contents Introduction Symbols and Decals Decals and machine-bound instructionsLocation of decals Decal Seed application chart Translation of instructionsSafety Instructions General useSafety Instructions Preparations Running Storage Movement/TransportChildren Fuel system Maintenance Presentation PresentationMain components and operating instruments Engine Throttle controlFuel valve StarterStarter handle ChokeOil dipstick Spark plugMuffler Oil drainageFuel tank FuelingDepth lock Cutting unit Depth leverDepth knob ClutchFlail blade Setting blade heightBlade versatility Delta bladeOperation Starting the engineCutting the engine Starting Before you startFinishing Maintenance Maintenance scheduleReplacing the air filter Cleaning the sludge reservoir Idle adjustmentIgnition system Fitting the wrong spark plug type can damage the engineChecking the drive belt Cutting unitReplacing the drive belt Wear/Rotation/Replacing flail blades When tipping the machine forward observe the Two minute rule Replacing worn flail bladesNuts Wear/Replacing spring tines Wear/Replacing delta bladesScrews Delta Blade Spring Tine ScrewCleaning and washing Two minute ruleLubrication schedule LubricationGeneral Engine oil Checking the engine’s oil levelDepth lever Depth knob with depth lockBlades HandleTroubleshooting Symptom Cause Engine will not startStorage ServiceWinter storage Technical Data Specifications DT22Assembly Instructions Assembly delivery serviceBagger Assembly Assembly directions, catcher bagAttach the chute to the mainframe Extender Wire tie the cable to the handle. See Instructions for the catcher bag Correct height settingCollection conditions Seeder Assembly Do not use or start the engine until the seeder is in placeRe-attach rubber flap rod with push nut to Seed Gate Cable Clamp Adjusting the seed hopper Instructions for the seederDelivery service Service JournalAfter the first 20 hours Sound Test Vibraton LevelPage Page ´z+H3J¶6T¨ Page 114 01 2003W10