Husqvarna DT22 manual Two minute rule, Cleaning and washing

Page 33

MAINTENANCE

Two minute rule

The machine may be tipped forward to facilitate access for cleaning or service, but no longer than 2 minutes.

If the machine is held in this position for too long, the engine can be damaged by gasoline draining into the crankcase. Should this happen, perform an extra oil change on the engine. Remove the spark plug and turn the engine over a few revolutions with the starter handle before starting the engine again.

Cleaning and washing

Regular cleaning and washing will increase the machine’s lifespan. Make it a habit to clean the machine directly after use, before the dirt sticks.

Check before rinsing that the fuel tank lid is properly in place to avoid getting water in the tank.

Use caution when using high-pressure spray because warning decals, instruction signs and the engine can be damaged. Do not exceed 70 bar/1000 PSI water pressure when cleaning.

Lubricate the machine after cleaning. This is particularly important if the machine is to be stored.

8011-248

8011-121

33

Image 33

Contents DT22 Table of Contents Introduction Decals and machine-bound instructions Symbols and DecalsLocation of decals Translation of instructions Decal Seed application chartGeneral use Safety InstructionsSafety Instructions Preparations Running Movement/Transport StorageChildren Fuel system Maintenance Presentation PresentationMain components and operating instruments Throttle control EngineStarter handle StarterFuel valve ChokeMuffler Spark plugOil dipstick Oil drainageFueling Fuel tankDepth knob Cutting unit Depth leverDepth lock ClutchBlade versatility Setting blade heightFlail blade Delta bladeStarting the engine OperationCutting the engine Before you start StartingFinishing Maintenance schedule MaintenanceReplacing the air filter Idle adjustment Cleaning the sludge reservoirFitting the wrong spark plug type can damage the engine Ignition systemCutting unit Checking the drive beltReplacing the drive belt Wear/Rotation/Replacing flail blades Replacing worn flail blades When tipping the machine forward observe the Two minute ruleScrews Delta Blade Wear/Replacing delta bladesNuts Wear/Replacing spring tines Spring Tine ScrewTwo minute rule Cleaning and washingLubrication Lubrication scheduleGeneral Checking the engine’s oil level Engine oilBlades Depth knob with depth lockDepth lever HandleSymptom Cause Engine will not start TroubleshootingService StorageWinter storage Specifications DT22 Technical DataAssembly delivery service Assembly InstructionsAssembly directions, catcher bag Bagger AssemblyAttach the chute to the mainframe Extender Wire tie the cable to the handle. See Correct height setting Instructions for the catcher bagCollection conditions Do not use or start the engine until the seeder is in place Seeder AssemblyRe-attach rubber flap rod with push nut to Seed Gate Cable Clamp Instructions for the seeder Adjusting the seed hopperService Journal Delivery serviceAfter the first 20 hours Vibraton Level Sound TestPage Page ´z+H3J¶6T¨ Page 2003W10 114 01