Husqvarna DT22 manual Sound Test, Vibraton Level

Page 51

Sound - Model 968999132

LWA

102

Sound Test

Sound test conducted was in accordance with 2000/14/EC and was performed on 07 October 2002 under the conditions listed.

General Condidtion: Clear

Temperature:

Wind Speed:

Test Report:

66 ° F.

Less than 8 mph

R092502-01

Vibration - Model 968999132

11.5

rms

Vibraton Level

Vibration level at the operators handles were measured in the vertical, lateral, and longitudinal directions using calibrated vibration test equipment.

Tests were performed on 07 October 2002 under the conditions listed:

General Condidtion: Clear

Temperature: 66 ° F.

Wind Speed:

Test Report:

Less than 8 mph

R092502-01

51

Image 51
Contents DT22 Table of Contents Introduction Decals and machine-bound instructions Symbols and DecalsLocation of decals Translation of instructions Decal Seed application chartGeneral use Safety InstructionsSafety Instructions Preparations Running Movement/Transport StorageChildren Fuel system Maintenance Presentation PresentationMain components and operating instruments Throttle control EngineChoke StarterStarter handle Fuel valveOil drainage Spark plugMuffler Oil dipstickFueling Fuel tankClutch Cutting unit Depth leverDepth knob Depth lockDelta blade Setting blade heightBlade versatility Flail bladeStarting the engine OperationCutting the engine Before you start StartingFinishing Maintenance schedule MaintenanceReplacing the air filter Idle adjustment Cleaning the sludge reservoirFitting the wrong spark plug type can damage the engine Ignition systemCutting unit Checking the drive beltReplacing the drive belt Wear/Rotation/Replacing flail blades Replacing worn flail blades When tipping the machine forward observe the Two minute ruleSpring Tine Screw Wear/Replacing delta bladesScrews Delta Blade Nuts Wear/Replacing spring tinesTwo minute rule Cleaning and washingLubrication Lubrication scheduleGeneral Checking the engine’s oil level Engine oilHandle Depth knob with depth lockBlades Depth leverSymptom Cause Engine will not start TroubleshootingService StorageWinter storage Specifications DT22 Technical DataAssembly delivery service Assembly InstructionsAssembly directions, catcher bag Bagger AssemblyAttach the chute to the mainframe Extender Wire tie the cable to the handle. See Correct height setting Instructions for the catcher bagCollection conditions Do not use or start the engine until the seeder is in place Seeder AssemblyRe-attach rubber flap rod with push nut to Seed Gate Cable Clamp Instructions for the seeder Adjusting the seed hopperService Journal Delivery serviceAfter the first 20 hours Vibraton Level Sound TestPage Page ´z+H3J¶6T¨ Page 2003W10 114 01