Husqvarna 15Ts AWD, 15T AWD manual Check the safety system

Page 23

Maintenance

Check the safety system

The machine is equipped with a safety system that prevents starting or driving under the following conditions.

The engine should only be possible to start when the cutting unit is in its raised position and the hydrostat pedals are in the neutral position.

The engine can not be started if the parking brake is not pressed down.

The driver does not need to be seated in the driver’s seat.

Make daily inspections to ensure that the safety system works by attempting to start the engine when one of the conditions is not met. Change the conditions and try again.

Check that the engine stops if you temporarily move out off the driver’s seat while the cutting unit is lowered or the hydrostat pedals are not in the neutral position.

Rider 15T

Rider 15T AWD and Rider 15Ts AWD

Start motor

Ignition system

Works

Does not work

English – 23

Image 23
Contents English Rider 15T Rider 15T AWD Rider 15Ts AWDContents After the first 8 hours Service journalPre-delivery service Introduction Symbols KEY to SymbolsKEY to Symbols What is what on the ride-on mower What is WHAT?General use Safety InstructionsSafety instructions Insure your RiderThis is what you do Driving on slopesChildren MaintenanceTransport Presentation Lights Cutting height adjustment leverCutting unit Lifting lever for the cutting unitClutch control Rider 15T AWD and Rider 15Ts AWD Exercise care and refuel outdoors see safety instructionsFuelling Release leverStart the engine DrivingBefore starting Remove the cables in the reverse order Starting the engine with a weak batteryConnecting the jump leads Driving the RiderStop the engine Cutting tipsMaintenance schedule MaintenanceRemoving of the machine hoods CleaningChecking and adjusting the steering wires Can result in reduced braking ability Adjusting the parking brake Rider 15TChecking and adjusting of throttle wire Cool before starting to replace the air filter Checking and adjusting the choke wireReplacement of fuel filter Replacing the air filterReplacing the spark plug Checking the fuel pump’s air filterIgnition system Check the safety system Checking the engine’s cooling air intake Replacing the light bulbsMain fuse Checking the tyre pressureLift up the cutting unit When the engine is running. Mind your fingersFitting the cutting head Trapping your handRemoving the cutting unit Replacing the cutting unit belts Adjusting the parallelism of the cutting unitHands when working with the blades Checking the cutting unit’s parallelismPlacing in the service position Service position for the cutting unitCombiClip 103, CombiClip Restoring from service positionChecking the blades Removing the BioClip plugReplacing the engine oil LubricationChecking the engine’s oil level Changing the oil filterGeneral lubrication Lubricating the belt adjusterChecking the transmission oil level Problem Procedure Troubleshooting scheduleGuard ServiceStorage Winter storageTechnical data Cutting unit CombiClip EN ISO 12100-2, EN-836 EC-declaration of conformity Applies to Europe onlyEC-declaration of conformity Page ´z+U+r¶6§¨ Page 1153118-26 ´z+U+r¶6§¨ ´z+U+r¶6§¨