Husqvarna 15Ts AWD, 15T AWD manual Cutting unit CombiClip

Page 35

Technical data

Cutting unit	CombiClip 94	CombiClip 103	CombiClip 112
Cutting width, mm/inch	940/37	1030 / 41	1120	/ 44.1
Cutting heights, 7 positions, mm/inch	25-75/0.98-2.95	25-75/0.98-2.95	25-75/0.98-2.95
Blade length, mm/inch	358/14.09	388/15.28	420 /	16,5

IMPORTANT INFORMATION When the service life of this product has been served and it is no longer used it should be returned to the dealer or to an applicable station for recycling.

IMPORTANT INFORMATION We reserve the right to change speciﬁcations and designs without prior notice so as to implement improvements.

Note that no legal claims are valid on the basis of information in this manual.

Use only genuine parts for repairs. The warranty is not valid if non genuine parts are used.

English – 35

Image 35

Contents English Rider 15T Rider 15T AWD Rider 15Ts AWDContents After the ﬁrst 8 hours Service journalPre-delivery service Introduction Symbols KEY to SymbolsKEY to Symbols What is what on the ride-on mower What is WHAT?General use Safety InstructionsSafety instructions Insure your RiderThis is what you do Driving on slopesChildren MaintenanceTransport Presentation Lights Cutting height adjustment leverCutting unit Lifting lever for the cutting unitClutch control Rider 15T AWD and Rider 15Ts AWD Exercise care and refuel outdoors see safety instructionsFuelling Release leverStart the engine DrivingBefore starting Remove the cables in the reverse order Starting the engine with a weak batteryConnecting the jump leads Driving the RiderStop the engine Cutting tipsMaintenance schedule MaintenanceRemoving of the machine hoods CleaningChecking and adjusting the steering wires Can result in reduced braking ability Adjusting the parking brake Rider 15TChecking and adjusting of throttle wire Cool before starting to replace the air ﬁlter Checking and adjusting the choke wireReplacement of fuel ﬁlter Replacing the air ﬁlterReplacing the spark plug Checking the fuel pump’s air ﬁlterIgnition system Check the safety system Checking the engine’s cooling air intake Replacing the light bulbsMain fuse Checking the tyre pressureLift up the cutting unit When the engine is running. Mind your ﬁngersFitting the cutting head Trapping your handRemoving the cutting unit Replacing the cutting unit belts Adjusting the parallelism of the cutting unitHands when working with the blades Checking the cutting unit’s parallelismPlacing in the service position Service position for the cutting unitCombiClip 103, CombiClip Restoring from service positionChecking the blades Removing the BioClip plugReplacing the engine oil LubricationChecking the engine’s oil level Changing the oil ﬁlterGeneral lubrication Lubricating the belt adjusterChecking the transmission oil level Problem Procedure Troubleshooting scheduleGuard ServiceStorage Winter storageTechnical data Cutting unit CombiClip EN ISO 12100-2, EN-836 EC-declaration of conformity Applies to Europe onlyEC-declaration of conformity Page ´z+U+r¶6§¨ Page 1153118-26 ´z+U+r¶6§¨ ´z+U+r¶6§¨

Technical data

Cutting unit

CombiClip 94