Husqvarna 15T AWD manual Service position for the cutting unit, Placing in the service position

Page 28

Maintenance

7Remove the screws on the cutting cover. Lift the unit frame and remove the cutting unit cover.

8Loosen the spring that tensions the V-belt and pry off the belt.

Assemble the parts in the reverse order.

Service position for the cutting unit

The cutting head can be placed in the service position to provide easy access for cleaning, repairs and servicing. In the service position the cutting unit is raised and locked in the vertical position.

Placing in the service position

1Position the machine on ﬂat ground. Apply the parking brake.

2Set the cutting height control in the lowest position and lift up the cutting unit.

3 Remove the front cover.

WARNING! Wear protective glasses when

!dismantling the cutting unit. The spring which tensions up the belt may break and cause personal injury.

4 Disengage the spring for the drive belt tensioning wheel.

5 Loosen on the cutting height stay and place in the holder.

	!	WARNING! Observe caution to avoid
	!	trapping your hand.
		trapping your hand.

6 Remove the drive belt and place it in the belt holder.

7Grip the front edge of the unit and pull forwards until it stops.

8Lift the unit until it stops and a clicking sound is heard. The unit locks automatically in the vertical position.

28 – English

Image 28

Contents Rider 15T Rider 15T AWD Rider 15Ts AWD EnglishContents Pre-delivery service Service journalAfter the ﬁrst 8 hours Introduction KEY to Symbols SymbolsKEY to Symbols What is WHAT? What is what on the ride-on mowerSafety Instructions Safety instructionsInsure your Rider General useDriving on slopes This is what you doMaintenance ChildrenTransport Presentation Cutting height adjustment lever Cutting unitLifting lever for the cutting unit LightsExercise care and refuel outdoors see safety instructions FuellingRelease lever Clutch control Rider 15T AWD and Rider 15Ts AWDBefore starting DrivingStart the engine Starting the engine with a weak battery Connecting the jump leadsDriving the Rider Remove the cables in the reverse orderCutting tips Stop the engineMaintenance Maintenance scheduleChecking and adjusting the steering wires CleaningRemoving of the machine hoods Checking and adjusting of throttle wire Adjusting the parking brake Rider 15TCan result in reduced braking ability Checking and adjusting the choke wire Replacement of fuel ﬁlterReplacing the air ﬁlter Cool before starting to replace the air ﬁlterIgnition system Checking the fuel pump’s air ﬁlterReplacing the spark plug Check the safety system Replacing the light bulbs Main fuseChecking the tyre pressure Checking the engine’s cooling air intakeWhen the engine is running. Mind your ﬁngers Fitting the cutting headTrapping your hand Lift up the cutting unitRemoving the cutting unit Adjusting the parallelism of the cutting unit Hands when working with the bladesChecking the cutting unit’s parallelism Replacing the cutting unit beltsService position for the cutting unit Placing in the service positionRestoring from service position Checking the bladesRemoving the BioClip plug CombiClip 103, CombiClipLubrication Checking the engine’s oil levelChanging the oil ﬁlter Replacing the engine oilChecking the transmission oil level Lubricating the belt adjusterGeneral lubrication Troubleshooting schedule Problem ProcedureService StorageWinter storage GuardTechnical data Cutting unit CombiClip EC-declaration of conformity EC-declaration of conformity Applies to Europe onlyEN ISO 12100-2, EN-836 Page ´z+U+r¶6§¨ Page 1153118-26 ´z+U+r¶6§¨ ´z+U+r¶6§¨