Charging Procedure
The standard charger provided will charge a fully depeleted battery | |
in about 4 hours. |
|
1. Plug the charger into an appropriate outlet before inserting the | |
battery pack. | 1 |
2. Insert the battery pack into the | |
charger as shown in figure 1. |
|
3. The green LED will flash |
|
indicating that the battery is being |
|
charged. |
|
4. The completion of charge |
|
is indicated by the green LED |
|
remaining on continuously. The |
|
pack is fully charged and may |
|
be used at this time or left on the |
|
charger. |
|
Recharge discharged batteries as soon as possible after use or | |
battery life may be greatly diminished. It is recommended that the | |
batteries be recharged after each use. | |
Important Charging Notes
1. Longest life and best performance can be obtained if the battery pack is charged when the air temperature is between 60°F and 80°F (16°- 27°C). DO NOT charge the battery pack in an air temperature below +40°F (+4.5°C), or above +105°F (+40.5°C). This is important and will prevent serious damage to the battery pack.
2. The charger and battery pack may become warm to touch while charging. This is a normal condition, and does not indicate a problem. To facilitate the cooling of the battery pack after use, avoid placing the charger or battery pack in a warm environment such as in a metal shed, or an uninsulated trailer.
3. If the battery pack does not charge properly:
a. Check current at receptacle by plugging in a lamp or other appliance
b. Check to see if receptacle is connected to a light switch which turns power off when you turn out the lights.
c. Move charger and battery pack to a location where the surrounding air temperature is approximately 60°F and 80°F (16°- 27°C)
d. If charging problems persist, take the tool, battery pack and charger to your local service center.
4. The battery pack should be recharged when it fails to produce sufficient power on jobs which were easily done previously.
DO NOT CONTINUE to use under these conditions. Follow the charging procedure. You may also charge a partially used pack whenever you desire with no adverse affect on the battery pack.
5. Foreign materials of a conductive nature such as, but not limited to, steel wool, aluminum foil, or any buildup of metallic particles should be kept away from charger cavities. Always unplug the charger from the power supply when there is no battery pack in the cavity. Unplug charger before attempting to clean.
6. Do not freeze or immerse charger in water or any other liquid. 
WARNING: Shock hazard. Do not allow any liquid to get
inside charger. Never attempt to open the battery pack for any reason. If the plastic housing of the battery pack breaks or cracks, return to a service center for recycling.
7