Black & Decker GH3000R instruction manual Troubleshooting, Maintenance, Service Information

sure to wind the line on neatly and in layers. Do not crisscross figure S.

•When the wound cutting line reaches the recesses (R4), cut the line and dock it in the spool line slots (R5) .

•Fit the spool cap onto the appliance as described in “REPLACING THE SPOOL” (figures

O, P).

Troubleshooting

Problem	Possible Cause	Possible Solution
• Unit will not start.	• Cord not plugged in.	• Plug appliance into a working outlet.
	• Circuit fuse is blown.	• Replace circuit fuse. (If the product
		repeatedly causes the circuit fuse to
		blow, discontinue use immediately and
		have it serviced at a Black+Decker
		service center or authorized servicer.)
	• Circuit breaker is tripped.	• Reset circuit breaker. (If the product
		repeatedly causes the circuit breaker to
		trip, discontinue use immediately and
		have it serviced at a Black+Decker
		service center or authorized servicer.)

•Cord or switch is damaged.

•Have cord or switch replaced at Black  +Decker Service Center or Authorized Servicer

•Cutting line is consumed quickly in edge mode.

• Edging too far from	• Ensure edging wheel is on the edge of
edge of sidewalks or	the surface and the cutting line is positioned
abrasive surfaces. The	in the grass or dirt area to be edged not
cutting line is hitting the	the sidewalk or other abrasive surface.

sidewalk or abrasive surface.

Maintenance

WARNING: Disconnect the plug from the power source before performing any maintenance.

CAUTION: To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment should be performed by authorized service centers or other qualified service organizations, always using identical replacement parts.

1.Keep the air intake slots clean to avoid overheating.

2.Your trimmer line can dry out over time. To keep your line in top condition, store spare pre-wound spools or bulk line in a plastic, sealable bag with a tablespoon of water.

3.Plastic parts may be cleaned by using a mild soap and a damp rag.

4.The line cutter on the edge of the guard can dull over time. It is recommended you periodically touch-up the sharpness of the blade with a file.

Service Information

All Black+Decker Service Centers are staffed with trained personnel to provide customers with efficient and reliable power tool service. Whether you need technical advice, repair, or genuine factory replacement parts, contact the Black+Decker location nearest you. To find your local service location call: 1-800-544-6986 or visit www.blackanddecker.com

12