Craftsman 247.77013.0 manual GAS and OIL FILL-UP

Page 13

OPERATION

Bag Handle

Used to grasp bag in order to assist in attaching, removing, and emptying bag. See Figure 10.

Bag

Collects shredded material fed through the chipper chute or vacuumed through the nozzle or hose.

Blower Chute

When attached to unit, the blower chute is used to discharge yard waste such as leaves, pine needle, or small twigs across yard.

Throttle Control

This lever controls the engine speed and stop function. Through three separate positions on the lever from left to right, the operation is as follows:

STOP

Start/ Run

Slow/ Idle

Engine Off

Choke Control

The choke control is used to choke the carburetor and assist in starting the engine.

Starter Handle

Used to start the engine.

GAS AND OIL FILL-UP

Oil (one bottle shipped with unit)

First Time Use

1.Remove oil fill dipstick.

2.With the Yard Vacuum on level ground, use a funnel to empty entire contents of oil bottle provided into the engine.

3.Replace oil fill dipstick and tighten.

Subsequent Uses

Only use high quality detergent oil rated with API service classification SF, SG, or SH. Select the oil’s SAE viscosity grade according to the expected operating temperature. Follow the chart below:

Colder Warmer

 

 

 

 

 

 

5W30

 

SAE30

 

 

 

Oil Viscosity Chart

Although multi-viscosity oils (5W30, 10W30, etc.) improve starting in cold weather, they will result in increased oil consumption when used above 32°F. Check your engine oil level more frequently to avoid possible engine damage from running low on oil.

1.Check the oil level making certain not to rub the dipstick along the inside walls of the oil fill tube. This would result in a false dipstick reading. Refill to FULL mark on dipstick, if necessary. Capacity is approximately 18 oz. Overfilling will cause the engine to smoke profusely and will result in poor engine performance.

2.Replace oil fill dipstick and tighten.

3.Keep oil level at FULL. Running the engine with too little oil can result in permanent engine damage.

WARNING

Use extreme care when handling gasoline. Gasoline is extremely flammable and the vapors are explosive. Never fuel machine indoors or while the engine is hot or running. Extinguish cigarettes, cigars, pipes, and other sources of ignition.

Gasoline

1.Remove fuel cap from the fuel tank.

2.Make sure the container from which you will pour the gasoline is clean and free from rust or foreign particles. Never use gasoline that may be stale from long periods of storage in its container.

Gasoline that has been sitting for any period longer than four weeks should be considered stale.

3.Fill fuel tank with clean, fresh, unleaded regular gasoline only. Do not use gasoline containing METHANOL. Replace fuel cap.

CAUTION

Use Alcohol blended fuels (called gasohol or using ethanol or metha- nol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage.

CAUTION

To avoid engine problems, the fuel system should be emptied before storage for 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See STORAGE Instructions for additional information.

CAUTION

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

NOTE: Check the fuel level periodically to avoid running out of gaso- line while operating the Yard Vacuum. If the unit runs out of gas as it is chipping, it may be necessary to unclog the discharge area before it can be restarted. Refer to SERVICE AND MAINTENANCE section.

13

Image 13
Contents Operator’s Manual Warranty Table of ContentsProduct Specifications Model Number Repair Protection Agreement Training Safety InstructionsPreparation Operation Maintenance & StorageDo not modify engine This page left intentionally blank To Avoid Serious Injury Safety LabelsOpening Carton AssemblyRemoving Unit from Carton Loose Parts in CartonAttaching the Handle Attaching the BAG Attaching the Hose AssemblyAttaching the Blower Chute Nozzle Height AdjustmentOperation GAS and OIL FILL-UP To Start Engine Attach spark plug wire and rubber boot to spark plugTo Stop Engine To Empty BAGUsing the Hose Assembly Using the Nozzle VacuumTo Remove Blower Chute Engine Maintenance Service and MaintenanceServicing the Air Cleaner General RecommendationsLubrication Clean EquipmentRemoving the Flail Screen Drive Control Cable AdjustmentRemove bag assembly or blower chute Disconnect and ground the spark plug wire to retaining postSharpening or Replacing Chipper Blade Nuts Impeller Gas in the tank † Under heavy load or in high temperatures Maintenance ScheduleEach Use Engine oil level Check Preparing the Engine OFF-SEASON StoragePreparing the yard vacuum Troubleshooting Parts List 710-1650 Description12 B 21 a 631-0090 Blower Chute 723-0400 Safety Glasses Not Shown  1 10 11Spring-Valve Intake Cylinder AssemblySpring-Valve Exhaust 694086 Guard-Flywheel272653†*†† Gasket-Air Cleaner 691753 Bracket-Air Cleaner PrimerHousing-Blower 695161 Cup/Screen Assembly66538 Boot-Spark Plug 617 270344†*†† Seal-O Ring Intake Manifold Switch-StopCover-Blower Housing Guard-Rewind 498144 Assembly-Pulley/Spring PulleyOwner’s Warranty Responsibilities Sears Emission Control Defects Warranty CoverageSears Emission Control Defects Warranty Provisions This page applicable in the U.S.A. and Canada onlyPage Garantía ÍndiceEspecificaciones DEL Producto Número DE ModeloAcuerdo DE Protección Para Reparaciones Capacitación Instrucciones DE SeguridadPreparativos Mantenimiento y almacenamiento OperaciónNo modifique el motor Apertura DE LA Caja DE Cartón MontajeCómo Sacar LA Unidad DE LA Caja Piezas Sueltas Dentro DE LA CajaBroches de horquilla. Vea la figura Montaje DE LA ManijaLos pernos del carro deben estar colocados de forma Adecuada en la manija. Vea la figuraManguera Instalación DEL Montaje DE LAMontaje DE LA Bolsa Ajuste DE LA Altura DEL Pico Instalar EL Canal DE SopladoLibere la palanca hacia la cubierta Operación Llenado DE Gasolina Y Aceite Para Detener EL Motor Para Encender EL MotorExtracción DEL Canal DE Soplado Descarga DE LA BolsaUSO DEL Pico DE LA Aspiradora USO DEL Montaje DE LA MangueraRecomendaciones Generales Servicio Y MantenimientoMantenimiento de Motor Servicio a La BujíaLimpieza DEL Equipo LubricaciónExtracción DE LA Pantalla DE DES- Granado Ajuste del Cable del Control de TransmisiònRetire el montaje de la bolsa o el canal de soplado Afilado O Reemplazo DE LAS Hojas DE LA CortadoraTornillos de cabeza plana Cada Uso Nivel del aceite de motor Comprobar Lista DE MantenimientoTanque † Bajo carga pesada o en temperaturas altas Preparación del Motor Almacenamiento Fuera DE TemporadaLa preparación del vacío de yarda Ya que los motores almacenaron más de 30 díasSolución DE Problemas Flujo de aire restringido El motor recalienta El nivel de aceite del motor es bajoMotor y alojamiento de soplador Quite la bujía y ajuste el huecoPiezas con garantía Esta página se aplica sólo en EE.UU. y CanadáMotor certificado Notas Call anytime, day or night MY-HOME1-800-469-4663