Homelite HL80833 Oxygenated Fuels, Adding gasoline to the Fuel tank, Applications

Page 14

operation

WARNING:

Do not allow familiarity with the product to make you care- less. Remember that a careless fraction of a second is sufficient to inflict serious injury.

WARNING:

Always wear eye protection with side shields marked to comply with ANSI Z87.1. Failure to do so could result in objects being thrown into your eyes resulting in possible serious injury.

WARNING:

OXYGENATED FUELS

DO NOT USE E85 FUEL. IT WILL VOID YOUR WAR- RANTY.

NOTE: Fuel system damage or performance problems re- sulting from the use of an oxygenated fuel containing more than the percentages of oxygenates stated below are not covered under warranty.

Ethanol. Gasoline containing up to 10% ethanol by volume (commonly referred to as E10) or 15% ethanol by volume (commonly referred to as E15) are acceptable. E85 is not.

adding gasoline to THE FUEL tank

See Figure 16.

WARNING:

Do not use any attachments or accessories not recom- mended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury.

WARNING:

Never direct a water stream toward people or pets, or any electrical device. Failure to heed this warning could result in serious injury.

Applications

You may use this product for the purposes listed below:

Using surface cleaner: removing dirt and mold from decks and cement patios

Using spray wand: cleaning boats, motorcycles, outdoor furniture, grills, and house siding

adding LUBRICANT to the engine

See Figure 15.

NOTE: This machine has been shipped with approximately 2 oz. of lubricant in the engine from testing. You must add lubricant to the engine before starting it the first time.

CAUTION:

Any attempt to start the engine without adding lubricant will result in engine failure not covered under warranty.

nPlace pressure washer on a flat, level surface.

nUnscrew the oil cap / dipstick by turning counter- clockwise.

nUsing 4-stroke engine lubricant (SAE 10W30), add engine oil until the fluid level rises to the upper fill level on the dipstick (18 oz., 4-cycle engine lubricant provided).

Do not overfill.

nReplace the oil cap / dipstick and securely tighten.

NOTE: This engine has a total lubricant capacity of 20 oz. (.6 liters).

Always shut off engine before fueling. Never add fuel to a machine with a running or hot engine. Move at least 30 ft. from refueling site before starting engine. Do not smoke! Failure to heed this warning could result in seri- ous personal injury.

When adding gas to the pressure washer, make sure the unit is sitting on a flat, level surface. If the engine is hot, let the pressure washer cool before adding gas. Always fill the fuel tank outdoors with the machine turned off.

NOTE: Use unleaded gas only. Do not mix lubricant with gas.

nBefore removing the fuel cap, clean the area around it. Remove the fuel cap.

nInsert a clean funnel into the fuel tank then slowly pour gasoline into the tank. Fill tank to approximately 1-1/2 in. below the top of the tank neck (this allows for fuel expansion).

nReplace fuel cap and tighten until the cap “clicks.”

nClean up any spills before starting the engine.

starting and stopping the pressure washer

See Figures 17 - 18.

caution:

Do not run the pump without the water supply connected and turned on.

Before starting the engine:

Connect all hoses.

Check all fluids (lubricant and gas).

Turn on the garden hose then squeeze the trigger to relieve air pressure; hold the trigger until a steady stream of water appears.

10 — English

Image 14
Contents Manual DEL Operador Save this Manual for Future ReferenceJardín que se enrollaautomáticamente­ Cleaning deck pont de nettoyer, unidad de limpieza Iii Carrying handles poignées de transport, mangos de traslado Table of Contents Important safety instructions Read ALL InstructionsSpecific Safety Rules Symbols Symbol NameBLEACHES, SOLVENTS, Flammable MATERIAL, or Industrial Soap Blaster Nozzle FeaturesProduct Specifications Spark ArrestorPacking List AssemblyUnpacking Trigger Handle Applications Oxygenated FuelsAdding gasoline to the Fuel tank Adding Lubricant to the engineWashing with detergent Using the spray wand triggerSELECTing the Right QUICK-CONNECT Nozzle for the JOB Lifting and moving the pressure washer­ Using the surface cleanerRinsing with the pressure washer To lift the pressure washerNozzle maintenance MaintenanceGeneral Maintenance Cleaning the air filterPreparing for use after storage Periodic maintenance schedule tableStoring the pressure washer Troubleshooting Problem Cause SolutionWarranty Limit ED NON Engine Warranty StatementEmission Related Parts Include the Following Lire Toutes LES Instructions Instructions Importantes Concernant LA SécuritéAVERTISSEMENT   Faire preuve de prudence pour éviter de glisser ou tomberRègles DE Sécurité Particulières Symboles Symbole Signal SignificationOU JAVÉLISÉS, NI DE Substances Inflammables OU DE Soap Blaster Buse CaractéristiquesEntreposage DU Tuyau Flexible Haute Pression PARE-ÉTINCELLESListe DE Contrôle AssemblageDéballage Assemblage de la lance d’arrosage Installation du tuyau d’injectionInstallation du plateau de nettoyage Connexion du flexible haute pression sur la pompeAppoint lubrifiant Moteur UtilisationCarburants Oxygénés Appoint D’ESSENCEMise en marche / arrêt du nettoyeur haute pression Fonctionnement poignée DE GâchetteUtilisation du plateau de nettoyage Nettoyage Avec DU DétergentRinçage Avec LE Nettoyeur Haute Pression Soulever et déplacer la laveuse à pressionNettoyage DU Filtre À AIR Entretien GénéralEntretien de buse Voir la figures 28Remise en service après remisage Remisage du nettoyeur haute pressionProblème Cause Solution DépannageGarantie Énoncé DE LA Garantie Limitée Hors MoteurII. Garantie DU Système Antipollution LEA Todas LAS Instrucciones Instrucciones DE Seguridad ImportantesAdvertencia Reglas DE Seguridad Específicas Precaución SímbolosPeligro Soluciones ÁCIDAS, ALCALINAS, Blanqueadores Características Lista DE Empaquetado ArmadoDesempaquetado Instalación DE LOS Sujetadores DEL Mango DEL GatilloInstalación DE LA Unidad DE Limpieza CóMO Conectar LA Manguera DE Alta PRESIóN a LA BombaCóMO Conectar LA Manguera DE INyECCIóN Para conectar una manguera de jardín a la máquinaAbASTECIMIENTO DE LubRICANTE DEL Motor FuncionamientoUsos Combustibles OxigenadosUso del mango del gatillo Encendido Y Apagado DE LA Lavadora DE PresiónPrecaución Lavado con detergenteCómo Levantar Y Mover LA Lavadora a Presión Enjuagado CON LA Lavadora DE PresiónUSO DE LA Unidad DE Limpieza Mantenimiento de las boquillas MantenimientoMantenimiento General Limpieza DEL Filtro DE AireGuardado DE LA Lavadora DE Presión Tabla del programa periódico de mantenimientoSolución de problemas Problema Causa SoluciónGarantía Declaración DE Garantía Limitada no Aplicable AL MotorGarantía Lavadora a Presión DE Gasolina 3 EN 1 DE Alta Velocidad OPERATOR’S ManualManuel D’UTILISATION Manual DEL Operador

HL80833 specifications

The Homelite HL80833 is a versatile and powerful gas-powered string trimmer designed for homeowners and landscaping professionals alike. With its lightweight design and robust performance, it has quickly gained popularity in the realm of outdoor gardening and lawn maintenance.

One of the standout features of the HL80833 is its 26cc, two-cycle engine. This engine provides a perfect balance of power and efficiency, allowing users to tackle tough weeds and overgrown lawns with ease. The trimmer's high-speed operation ensures that grass and weeds are trimmed quickly, saving time and effort.

Another significant advantage of the Homelite HL80833 is its ease of use. The trimmer is equipped with an automatic feed spool, which allows for continuous line feed while in operation. This feature eliminates the need for manual adjustments, letting users focus on their trimming tasks without interruption. The dual-line cutting system further enhances its efficiency, providing a 17-inch cutting width that covers more ground in a single pass.

Ergonomics and user comfort are also vital considerations in the design of the HL80833. The trimmer features a comfortable handlebar grip and adjustable harness that help minimize fatigue during extended use. Additionally, the lightweight structure of the unit makes it easy to maneuver around obstacles and tight spaces, making it an ideal choice for residential gardens and professional landscaping projects.

The Homelite HL80833 incorporates innovative technologies to ensure optimal performance, including a spring-assisted starting system. This feature allows for quick and easy start-up, reducing the frustration often associated with gas-powered equipment. The trimmer also comes with a durable housing that can withstand the rigors of outdoor use, and its design promotes better airflow for cooling, preventing overheating during prolonged operation.

Maintenance is simplified with the HL80833, as most components are easily accessible for cleaning and repairs. The trimmer's fuel efficiency and eco-friendly approach, thanks to lower emissions, make it a responsible choice for environmentally conscious users.

In summary, the Homelite HL80833 is an efficient and user-friendly string trimmer that combines powerful performance with ease of use. Its advanced features, lightweight design, and ergonomic considerations make it an excellent choice for anyone looking to maintain their outdoor spaces effectively. Whether for a home garden or a professional landscaping job, the HL80833 proves to be a reliable and capable tool in the hands of its users.