Homelite HL80833 manuel dutilisation Storing the pressure washer, Preparing for use after storage

Page 18

MAINTENANCE

STORING the pressure washer

See Figure 32.

Store the pressure washer with the gas tank empty by either draining the tank or running the pressure washer until the gas runs out. Allow 30 minutes of “cool down” time before storing the machine. Store in a dry, covered area where the weather can’t damage it.

It is important to store this product in a frost-free area. Always empty water from all hoses and the pump before storing.

NOTE: Use of a fuel stabilizer and pump saver will give you better performance and increase the life of the machine.

Discharge Fuel:

Drain the fuel tank completely. Stored gas can go stale in 30 days.

Engine Lubricant:

Drain the lubricant and replace with fresh, clean lubricant.

Spark Plug:

nDisconnect spark plug wire and remove the spark plug. Pour about a teaspoon of clean, air-cooled, four-cycle lubricant through the spark plug hole into the combustion chamber.

nLeaving the spark plug out, pull the starter cord two or three times to coat the inside of the cylinder wall.

nInspect the spark plug and clean or replace, as necessary.

nReinstall the spark plug, but leave the spark plug wire disconnected.

Air Filter:

nClean the air filter.

Hoses and Pump:

Flush the injection hose with clean water for 1-2 minutes. Remove all hoses. Empty the pump by pulling on the recoil starter about 6 times. This should remove most of the liquid from the pump.

Handlebar:

NOTE: Before lowering the handlebar, disconnect the high pressure water hose from the trigger handle outlet coupler.

nTo lower the handlebar for storage, remove the acorn nut and knob.

nRotate handlebar forward to the next indentation in handle spacer.

nRetighten knob and acorn nut to secure.

preparing for use after storage

nRestore handle to operating position.

nPull the recoil starter grip three or four times to clean lubricant from the combustion chamber.

nRemove spark plug from the cylinder. Wipe lubricant from the spark plug and return it to the cylinder.

nReconnect the spark plug wire.

nRefuel the machine as described earlier in the operator’s manual.

periodic maintenance schedule table

Maintenance Items

Each

Every

Every

Every

Every

Every

 

use

8 hrs.

20 hrs.

50 hrs.

100 hrs.

300 hrs.

 

 

 

 

 

 

 

Clean engine & check bolts & nuts

X

X

 

 

 

 

Check engine oil

X

 

 

 

 

 

Change engine oil*

 

 

X

 

 

 

Clean spark plug

 

 

 

 

X

 

Clean air cleaner

X

 

 

X

 

 

Replace air cleaner element

 

 

 

X

 

 

Clean & adjust spark plug & electrodes

 

 

 

 

X

 

Replace spark plug

 

 

 

 

X

 

Remove carbon from cylinder head**

 

 

 

 

 

X

Check & adjust valve clearance**

 

 

 

 

 

X

 

 

 

 

 

 

 

*Initial oil change should be performed after the first 20 hours of operation. Do not pour old oil down sewage drains, into garden soil, or into open streams. Your local zoning or environmental regulations will give you more detailed instruction on proper disposal.

** Have performed by your nearest service center

14 — English

Image 18
Contents Manual DEL Operador Save this Manual for Future ReferenceJardín que se enrollaautomáticamente­ Cleaning deck pont de nettoyer, unidad de limpieza Iii Carrying handles poignées de transport, mangos de traslado Table of Contents Important safety instructions Read ALL InstructionsSpecific Safety Rules Symbols Symbol NameBLEACHES, SOLVENTS, Flammable MATERIAL, or Industrial Soap Blaster Nozzle FeaturesProduct Specifications Spark ArrestorAssembly UnpackingPacking List Trigger Handle Applications Oxygenated FuelsAdding gasoline to the Fuel tank Adding Lubricant to the engineUsing the spray wand trigger SELECTing the Right QUICK-CONNECT Nozzle for the JOBWashing with detergent Lifting and moving the pressure washer­ Using the surface cleanerRinsing with the pressure washer To lift the pressure washerNozzle maintenance MaintenanceGeneral Maintenance Cleaning the air filterPeriodic maintenance schedule table Storing the pressure washerPreparing for use after storage Troubleshooting Problem Cause SolutionWarranty Limit ED NON Engine Warranty StatementEmission Related Parts Include the Following Lire Toutes LES Instructions Instructions Importantes Concernant LA SécuritéAVERTISSEMENT   Faire preuve de prudence pour éviter de glisser ou tomberRègles DE Sécurité Particulières Symboles Symbole Signal SignificationOU JAVÉLISÉS, NI DE Substances Inflammables OU DE Soap Blaster Buse CaractéristiquesEntreposage DU Tuyau Flexible Haute Pression PARE-ÉTINCELLESAssemblage DéballageListe DE Contrôle Assemblage de la lance d’arrosage Installation du tuyau d’injectionInstallation du plateau de nettoyage Connexion du flexible haute pression sur la pompeAppoint lubrifiant Moteur UtilisationCarburants Oxygénés Appoint D’ESSENCEMise en marche / arrêt du nettoyeur haute pression Fonctionnement poignée DE GâchetteUtilisation du plateau de nettoyage Nettoyage Avec DU DétergentRinçage Avec LE Nettoyeur Haute Pression Soulever et déplacer la laveuse à pressionNettoyage DU Filtre À AIR Entretien GénéralEntretien de buse Voir la figures 28Remise en service après remisage Remisage du nettoyeur haute pressionProblème Cause Solution DépannageGarantie Énoncé DE LA Garantie Limitée Hors MoteurII. Garantie DU Système Antipollution Instrucciones DE Seguridad Importantes AdvertenciaLEA Todas LAS Instrucciones Reglas DE Seguridad Específicas Símbolos PeligroPrecaución Soluciones ÁCIDAS, ALCALINAS, Blanqueadores Características Lista DE Empaquetado ArmadoDesempaquetado Instalación DE LOS Sujetadores DEL Mango DEL GatilloInstalación DE LA Unidad DE Limpieza CóMO Conectar LA Manguera DE Alta PRESIóN a LA BombaCóMO Conectar LA Manguera DE INyECCIóN Para conectar una manguera de jardín a la máquinaAbASTECIMIENTO DE LubRICANTE DEL Motor FuncionamientoUsos Combustibles OxigenadosUso del mango del gatillo Encendido Y Apagado DE LA Lavadora DE PresiónPrecaución Lavado con detergenteEnjuagado CON LA Lavadora DE Presión USO DE LA Unidad DE LimpiezaCómo Levantar Y Mover LA Lavadora a Presión Mantenimiento de las boquillas MantenimientoMantenimiento General Limpieza DEL Filtro DE AireGuardado DE LA Lavadora DE Presión Tabla del programa periódico de mantenimientoSolución de problemas Problema Causa SoluciónGarantía Declaración DE Garantía Limitada no Aplicable AL MotorGarantía OPERATOR’S Manual Manuel D’UTILISATION Manual DEL OperadorLavadora a Presión DE Gasolina 3 EN 1 DE Alta Velocidad

HL80833 specifications

The Homelite HL80833 is a versatile and powerful gas-powered string trimmer designed for homeowners and landscaping professionals alike. With its lightweight design and robust performance, it has quickly gained popularity in the realm of outdoor gardening and lawn maintenance.

One of the standout features of the HL80833 is its 26cc, two-cycle engine. This engine provides a perfect balance of power and efficiency, allowing users to tackle tough weeds and overgrown lawns with ease. The trimmer's high-speed operation ensures that grass and weeds are trimmed quickly, saving time and effort.

Another significant advantage of the Homelite HL80833 is its ease of use. The trimmer is equipped with an automatic feed spool, which allows for continuous line feed while in operation. This feature eliminates the need for manual adjustments, letting users focus on their trimming tasks without interruption. The dual-line cutting system further enhances its efficiency, providing a 17-inch cutting width that covers more ground in a single pass.

Ergonomics and user comfort are also vital considerations in the design of the HL80833. The trimmer features a comfortable handlebar grip and adjustable harness that help minimize fatigue during extended use. Additionally, the lightweight structure of the unit makes it easy to maneuver around obstacles and tight spaces, making it an ideal choice for residential gardens and professional landscaping projects.

The Homelite HL80833 incorporates innovative technologies to ensure optimal performance, including a spring-assisted starting system. This feature allows for quick and easy start-up, reducing the frustration often associated with gas-powered equipment. The trimmer also comes with a durable housing that can withstand the rigors of outdoor use, and its design promotes better airflow for cooling, preventing overheating during prolonged operation.

Maintenance is simplified with the HL80833, as most components are easily accessible for cleaning and repairs. The trimmer's fuel efficiency and eco-friendly approach, thanks to lower emissions, make it a responsible choice for environmentally conscious users.

In summary, the Homelite HL80833 is an efficient and user-friendly string trimmer that combines powerful performance with ease of use. Its advanced features, lightweight design, and ergonomic considerations make it an excellent choice for anyone looking to maintain their outdoor spaces effectively. Whether for a home garden or a professional landscaping job, the HL80833 proves to be a reliable and capable tool in the hands of its users.