Husky HD1500 Troubleshooting, Problem or Concern Possible Cause Solution, Water in the unit

English

8.0 TROUBLESHOOTING

PROBLEM OR CONCERN	POSSIBLE CAUSE	SOLUTION
Detergent is not dispensing	Detergent suction tube has been	Remove the soap lance assembly from the de-
	disconnected or clogged.	tergent bottle. Make sure that the clear tube is
		properly connected to the soap lance. If it is not
		connected then reconnect it.
Detergent to Water ratio		Your Powerwasher draws detergent at a 10:1
		ratio. Most pressure washer detergents are gene-
		rally concentrated within that range so minimal
		adjustment is required. If you feel like you are
		using more detergent than is required for the ap-
		plication you can dilute it with regular tap water.
Detergent - What to use		We recommend that you use a cleaner which is
		specifically designed for power washers. There
		are different kinds available depending on the
		application. Check with your local Home Depot
		store for the product which is best suited for
		your needs.
		Never use Bleach, Ammonia or Hot
		water in the unit.
Circuit breaker trips or Fuse	Circuit overload	Check that the circuit is rated at 15 amps or
blown in Fuse Box		greater. Make sure the unit is plugged into a
		dedicated circuit.
	Extension cord too long or wire	Use proper extension cord as recommended in
	size too small	owner’s manual.
	Nozzle partially blocked	Clean Nozzle as instructed in section 6.2.
	Excessive pressure	Clean Nozzle as instructed in section 6.2
GFCI Plug installation		For GFCI reset procedures see owner’s manual
		section 4.3. For instructions regarding the GFCI
		Plug installation or malfunction please email us
GFCI Plug malfunction		directly at customerservice@huskypowe
		rwasher.com.
Gun/Hose - Leaking water		Gun/Hose will need to be replaced. Replace-
		ment parts are not available for the Gun/Hose.
		Email us at customerservice@huskypow
		erwasher.com for assistance or order onli-
		ne at www.huskypowerwasher.com.
Leaking Oil from Pump	A small amount of leakage is	If leakage occurs please contact us directly at custo
	normal	merservice@huskypowerwasher.com.
Leaking water from bottom	Machine Inlet connection is de-	Check the Machine Inlet at the back of the unit to
of unit	fective	ensure that water is not leaking from it. If the con-
		nection is leaking it will have to be replaced.
		Contact us at customerservice@huskypow
		erwasher.com or order a replacement directly
		online at www.huskypowerwasher.com.

18