Husky HD1500 warranty Huskypowerwasher.com

English

PROBLEM OR CONCERN	POSSIBLE CAUSE	SOLUTION
No water coming out of	Gun/Hose Assembly is defec-	Attach the Gun/Hose to the front of the unit with no
Wand	tive	wand attached to the Gun. Squeeze the trigger of
		the gun to ensure that water comes out of the front
		of the Gun at a rate equal to the Garden Hose. If no
		water comes out of the Gun, remove the gun and
		the hose to ensure that water flows out of the pump.
		If it does, the gun will need to be replaced. Contact
		us at customerservice@huskypowerwash
		er.com or order a replacement directly online at
		www.huskypowerwasher.com.
Trigger will not move	Gun Safety Lock in engaged	Release Safety Lock as instructed in Manual.
Unit will not start	Unit is not turned on	Press ON/OFF Switch into ON position.
Note: Unit will only start when
	Loose or disconnected Plug	Reconnect Plug.
trigger is depressed.
	Defective GFCI Plug	Perform GFCI reset procedure as instructed in
Unit stops while operating		Section 2.0. If the Plug does not reset it will
		need to be replaced. Contact us at custome
		rservice@huskypowerwasher.com or
		order a replacement directly online at www.
		huskypowerwasher.com.
	Extension Cord length or gauge	Use proper Extension Cord as instructed in section
	incorrect	2.0.
	Gun trigger not operating pro-	Contact us at customerservice@huskypow
	perly	erwasher.com or order a replacement directly
		online at www.huskypowerwasher.com.
	Defective Gun	Remove the Gun and Hose assembly from the front
		of the unit. Aim water stream away from electric
		source and switch the unit into the ON position.
		If the unit starts and water comes out of the front,
		the Gun may need to be replaced. Contact us at
		customerservice@huskypowerwasher.
		com or order a replacement directly online at
		www.huskypowerwasher.com.
	Tripped Pressure washer Ther-	Allow to cool and restart unit.
	mal Switch
	Defective ON/OFF Switch	Contact us at customerservice@huskypow
		erwasher.com or order a replacement directly
		online at www.huskypowerwasher.com.
Unit will not stop when trig-	Screen filter is clogged	Clean the Screen filter as instructed in the sec-
ger is released		tion 6.4.
	Garden Hose is kinked or	Make sure the Garden Hose is laid out flat and
	leaking water	there are no kinks in it. The hose should not be
		wrapped on a storage wheel. Make sure the
		faucet is open all the way and there is a full
		volume of water reaching the unit.
	Wand is malfunctioning	Test both wands to ensure that one is not mal-
		functioning.
	Gun is not operating properly	Remove Wand from the Gun and squeeze trigger to
		ensure that the water is coming out of the front of the
		Gun at a rate equal to the Garden Hose.

20