Installation, Pressure Washer Assembly Fig

English

INSTALLATION

Pressure Washer Assembly (Fig. 1)

1.Place handle assembly (O) onto frame, depress the snap buttons, and slide the handle assembly onto the frame (F) until snap buttons are secured

in place.	O

Caution: Risk of personal injury. Avoid placing F hands between handle and frame when assembling to prevent pinching.

NOTE: The high-pressure pump was filled with oil at the factory. Always check oil level before using (refer to Maintenance for more information).

Warning: Risk of bursting. Use a tire pressure gauge to check the tires pressure before each use and while inflating tires; see the tire side- wall for the correct tire pressure.

NOTE: Air tanks, compressors and similar equipment used to inflate tires can fill small tires similar to these very rapidly. Adjust pressure regulator on air supply to no more than the rating of the tire pressure. Add air in small increments and frequently use the tire gauge to

2.Attach high-pressure hose (P) to spray gun. Make sure it is secure.

3.Connect wand (E) to spray gun. Make sure connection is secure.

prevent over inflation.

OPERATION

Pressure Adjustments

The pressure setting is preset at the factory to achieve optimum pres sure and cleaning. To lower the pressure, follow these instructions.

1. Back away from the surface to be cleaned. The further away you

4.	Thread the side handle (D) into spray
	gun extension and tighten to desired
	position.
5.	Place the nozzle holder (B) onto the
	panel assembly (A) and push each	D
	nozzle holder into place.	D
	nozzle holder into place.

6.Remove the five colored quick-connect nozzles from the plastic bag and

insert	them	into
correct grommet on			B
the nozzle holder.			B
the nozzle holder.
Nozzles	are	color	A
coded	to	match	A
colored	nozzles on

panel assembly.

are, the less the pressure will be on the surface to be cleaned.

2. Change to the 40˚ nozzle (white). This nozzle delivers a less

powerful stream of water and a wider spray pattern. Refer to

Spray Wand Nozzles.

Caution: DO NOT attempt to increase pump pressure. A higher pressure setting than the factory set pressure may damage pump.

3.Reduce the speed of the gasoline engine (RPM). Slow the engine down and the water pressure will go down with it.

Spray Wand Nozzles (Fig. 1)

The nozzles for the spray wand are stored in the nozzle holder (B) on the panel assembly (A). Colors on the panel identify nozzle location and spray pattern. Refer to the following chart to choose the correct nozzle for the job to be performed.