5. Direct water supply into spray wand to back flush loosened particles for 30 seconds.
6.Reassemble the nozzle to the wand.
7.Reconnect spray wand to gun then turn on water supply.
8.Start pressure washer and place spray wand into high pressure setting to test.
To Clean the Water Inlet Filter
This filter screen (U) should be checked periodically and cleaned if necessary.
1. Remove the filter screen (U) by grasping the
end and removing it from water inlet of pump.
2. Clean filter by flushing it with water on both sides.
3. Reinsert filter into water inlet of pump. Cone | U | |
side faces out. | ||
| ||
NOTE: Do not operate pressure washer without |
| |
flter properly installed. |
|
To Remove Tires
1. Using a 1/8" hex head wrench loosen set screw in hub collar.
2. Slide hub collar from axle and remove the 
tire.
sTORAGE Engine
Consult the engine instruction manual for the manufacturer's recommendations for storage.
Pump
The manufacturer recommends using a pump protector/winter- izer, such as DeWALT winterizer (DP80) when storing the unit for more than 30 days and/or when freezing temperatures are expected. DeWALT winterizer (DP80) is availabe at the store where the pressure washer was purchased. If a pump protector/ winterizer is not available, RV antifreeze can be used as outlined in the following steps.
NOTE: Using a pump protector/ winterizer or RV antifreeze helps to provide proper lubrication to the internal seals of the pump regard- less of temperature or environment.
1. Obtain a funnel, 6 oz. (170 mL) of RV antifreeze and
CAUTION: Risk of property damage. Use only RV antifreeze. Any other antifreeze is corrosive and can dam- age pump.
2. Disconnect spark plug wire.
3. Connect length of garden hose to water inlet of pump.
4.Add RV antifreeze to hose as shown.
5.Pull engine starter rope slowly several times until antifreeze comes out of
6.Remove garden hose from water inlet of pump.
7.Reconnect spark plug wire.
English
15