Pressure Washer
Frequently Asked Questions
How do I start my pressure washer?
1.Make sure you have gas and oil in the engine. The engine DOES NOT COME FILLED WITH OIL.
2.Turn the water on, then trigger the gun to make sure the water will flow smoothly out of the tip.
3.Open the fuel shutoff valve by turning the knob counterclockwise until it stops.
4.Close the choke (if engine is cold) by moving the choke ring fully to the right.
5.Set the shut off switch to “ON.”
6.Pull the trigger (to relieve any back pressure in the pump) while pulling the starter cord.
What type of oil do I use?
ENGINE DOES NOT COME FILLED WITH OIL: See Page 10 for engine oil types, quantities, and oil changing instructions.
Pump: The pump comes filled with the correct amount of oil and should not need changing or filling.
Why don’t I have any water pressure?
•Is the water hose attached to the pressure washer?
•Is the water turned on?
•Check for any kinks, leaks, or blockage in the hoses, fittings, or the nozzle.
•Is the 15º (yellow) spray tip inserted into the end of the lance (See Page 8)?
•Is the inlet filter screen free of debris? Check and remove debris if needed.
How do I get high pressure?
•For high pressure, insert the 15º (yellow) spray tip into the end of the lance (See Page 8).
How do I get the soap suction to work?
1.Connect the clear plastic chemical suction tube to the plastic hose barb on detergent tank.
2.Fill the detergent tank with detergent forumlated for use with pressure washers.
3.To spray soap, insert the 65° (black) soap spray tip into the end of the lance (see page 8).
Why doesn’t the pressure washer apply detergents with high pressure?
Detergents “bounce” off cleaning surfaces as fast as they are applied. The pressure washer’s features allow for a detergent to be drawn while in low pressure mode only. By applying detergent at low pressure, the effect of “bouncing” is reduced. Also, detergents are only effective when time is allowed for them to work on the surface of whatever is being cleaned. After applying the detergent, wait
What maintenance do I need to perform on my pressure washer?
1.After turning off the pressure washer and the water, depressurize the hose by triggering the gun.
2.Remove the garden hose and high pressure hose from the pump.
3.Pull the start rope slowly five times to purge water from the pump. This will help protect the pump from damage.
4.Do not store your pressure washer in an area where the temperature will drop below 32˚ F.
5.Follow proper storage and winterizing instructions found on page 9.
What do I do if I’m missing a part?
Call Campbell Hausfeld at
PRESSURE WASHER TO THE RETAILER!
Where can I buy accessories for my pressure washer?
•If you can’t find accessories at the store where you purchased your pressure washer, call Campbell Hausfeld at
Who do I call if I have questions or problems?
Call Campbell Hausfeld at
3
www.chpower.com