Generac 004700-0 Cleaning The Generator, Battery Maintenance, Weekly, Every Six Months, Danger

Page 16
3.8CLEANING THE GENERATOR

Section 3 – Maintenance

QUIETPACT 40G Recreational Vehicle Generator

3.8CLEANING THE GENERATOR

Keep the generator set as clean and dry as possible. Protect the unit against excessive dust, dirt, corrosive vapors, road splash, etc. Permitting dirt and mois- ture to accumulate on generator windings will have an adverse effect on the insulation resistance of those windings.

When moisture is allowed to remain in contact with windings, some of the moisture will be retained in voids and cracks in the insulation. This causes a reduced insulation resistance and will eventually cause problems. Dirt will make the problem worse, since dirt tends to hold moisture in contact with windings. Salt (as from sea air) also will worsen the problem since it tends to absorb moisture from the air. Salt and moisture, when combined, form a good electrical conductor which can be damaging to the generator windings.

Do NOT use a forceful spray of water to clean

!the generator. Water will enter the generator interior and cause problems, and may also cont- aminate the generator fuel system.

3.9BATTERY MAINTENANCE

All lead-acid batteries will discharge when not in use. The generator battery should be inspected as follows:

3.9.1 WEEKLY

Inspect the battery posts and cables for tightness and corrosion. Tighten and clean as necessary.

Check the battery fluid level of unsealed batteries and, if necessary, fill with Distilled Water Only. Do not use tap water in batteries.

3.9.2 EVERY SIX MONTHS

Have the state of charge and condition checked. This should be done with an automotive-type bat- tery hydrometer.

NOTE:

Servicing of the battery is to be performed or supervised by personnel knowledgeable of batter- ies and the required precautions. Keep unautho- rized personnel away from batteries.

Damage will result if the battery connections are made in reverse.

Do NOT use a forceful spray of water to clean3.9BATTERY MAINTENANCE DANGER

Do not dispose of the battery in a fire. The battery is capable of exploding. Storage batter- ies give off explosive hydrogen gas. This gas can form an explosive mixture around the bat- tery for several hours after charging. The slightest spark can ignite the gas and cause an explosion. Such an explosion can shatter the battery and cause blindness or other injury. Any area that houses a storage battery must be properly ventilated. Do not allow smoking, open flame, sparks, or any spark producing tools or equipment near the battery. Discharge static electricity from your body before touch- ing the battery by first touching a grounded metal surface.

A battery presents a risk of electrical shock and high short circuit current. The following precautions are to be observed when working on batteries:

Remove watches, rings or other metal objects;

Use tools with insulated handles;

Wear rubber gloves and boots;

Do not lay tools or metal parts on top of the battery;

Disconnect any charging source prior to connecting or disconnecting battery terminals; and

Do not use any jumper cables or booster battery to crank and start the generator engine. If any battery has discharged, remove it for recharging.

Do not open or mutilate the battery. Released

!electrolyte has been known to be harmful to the skin and eyes, and to be toxic.

The electrolyte is a dilute sulfuric acid that is

!harmful to the skin and eyes. It is electrically conductive and corrosive. The following procedures are to be observed:

Wear full eye protection and protective clothing;

Where electrolyte contacts the skin, wash it off immediately with water;

Where electrolyte contacts the eyes, flush thoroughly and immediately with water and seek medical attention; and

Spilled electrolyte is to be washed down with an acid neutralizing agent. A common practice is to use a solution of 1 pound (500 grams) bicarbonate of soda to 1 gallon (4 liters) or water. The bicar- bonate of soda solution is to be added until the evidence of reaction (foaming) has ceased. The resulting liquid is to be flushed with water and the area dried.

14 Generac® Power Systems, Inc.

Image 16
Contents Air-cooled Recreational Vehicle Generators This manual should remain with the unitModel QUIETPACT 40G GENERA OHVIAUTHORIZED SERVICE DEALER LOCATION CONTENTSOPERATION AND MAINTENANCE HOW TO OBTAIN SERVICEPart II - Installation Instructions Safety RulesAdjustments Exploded Views and Parts ListsGENERAL HAZARDS Despite the safe design of this generatorParts of the generator are rotating and/or hot during operation. Exercise care near running generatorsFIRE HAZARDS ELECTRICAL HAZARDSEXPLOSION HAZARDS 1.1 GENERATOR IDENTIFICATION Model 004700-0 - QUIETPACT 40GModel Number kW Rating1.3 SAFETY 1.5 SPECIFICATIONSDo not overload the generator. Some installa 1.2 GENERATOR APPLICABILITYGenerac does not recommend using any 1.5.5 GENERATOR1.5.2 FUEL CONSUMPTION 1.5.3 ENGINE OIL REQUIREMENTS2.1.2 START/STOP SWITCH 2.4.1 INSTALLATION2.1 GENERATOR CONTROL PANEL 2.2 OPTIONAL REMOTE START/STOP PANEL2.5 STARTING THE GENERATOR 2.4.2 ENGINE LUBRICATION2.4.3 FUEL SUPPLY 2.4.4 COOLING AND VENTILATING AIR2.9.1 LOW OIL PRESSURE SWITCH 2.9.2 HIGH TEMPERATURE SWITCHFigure 2.2 - Low Oil Pressure and High Temperature Switches 2.6 STOPPING THE GENERATOR2.10 ADDITIONAL INFORMATION 2.9.3 FIELD BOOST2.10.1 25-HOUR BREAK-IN PERIOD 2.9.4 OVERVOLTAGE PROTECTIONFigure 3.1 - Oil Maintenance Features 3.1 CHECKING THE ENGINE OIL LEVEL3.2 CHANGING THE ENGINE OIL AND/OR OIL FILTER 2.10.4 OPERATION IN HIGH GRASS OR BRUSH3.3 MAINTAINING THE ENGINE AIR CLEANER 3.3.1 CLEANING THE FOAM PRECLEANERFigure 3.2 - Engine Air Cleaner 3.3.2 CLEANING OR REPLACING THE PAPER FILTER3.4 CLEAN AIR INTAKE 3.7 CLEAN SPARK ARRESTORFigure 3.3 - Cleaning Air Intake Figure 3.4 - Setting the Spark Plug Gap3.8 CLEANING THE GENERATOR 3.9 BATTERY MAINTENANCEDo NOT use a forceful spray of water to clean Use tools with insulated handles Wear rubber gloves and boots3.12 OUT OF SERVICE PROCEDURE 3.13 ADJUSTING VALVE CLEARANCE3.12.1 REMOVAL FROM SERVICE 3.12.2 RETURN TO SERVICE3.14 RV GENERATOR SERVICE INTERVAL Figure 3.8 - Tightening Jam NutINSTALLATION INSTRUCTIONS SHOULD ATTEMPT INSTALLATIONPART ONLY QUALIFIED ELECTRICIANS OR CONTRACTORSNOTICE TO INSTALLER FIRE HAZARDS 1.2 SAFETY 1.1 PURPOSE AND SCOPE OF THE MANUAL1.4 EQUIPMENT DESCRIPTION 1.5 GENERATOR ENGINE OPERATING SPEEDMajor Features VIEW FROM TOP2.1 LOCATION AND SUPPORT 2.1.1 GENERATOR LOCATION2.1.2 GENERATOR SUPPORT 2.1.3 SUSPENDED MOUNTING2.2 GENERATOR COMPARTMENTS 2.1.4 GENERATOR RESTRAINT2.2.2 COMPARTMENT CONSTRUCTION 2.2.1 COMPARTMENT SIZE2.2.3 SOUND INSULATING MATERIALS 2.2.4 ACOUSTICSFigure 2.6 - Types of Lock Seams Figure 2.7 - Typical Noise Abatement 2.2.5 COMPARTMENT FLOOR CUTOUTS Figure 2.8 - Compartment Floor Cutout Drawing 0D8716-CVIEW FROM TOP All measurements are in millimeters, 25.4 mm = 1”2.3.2 TESTING THE INSTALLATION 2.3 COOLING AND VENTILATING AIR2.4 GASOLINE FUEL SYSTEM 2.3.1 GENERATOR AIRFLOW2.5 EXHAUST SYSTEM 2.4.1 FUEL TANK2.4.2.2 Flexible Fuel Line 2.4.2 GENERATOR FUEL SUPPLY LINE 2.4.2.1 Rigid Fuel Lines2.5.2 EXHAUST SYSTEM SAFETY Figure 2.12 - Spark Arrestor Installation2.6 ELECTRICAL CONNECTIONS 2.5.1 SPARK ARRESTOR2.6.2 WIRING 2.6.1 ELECTRICAL JUNCTION BOX2.6.3 GENERATOR AC CONNECTIONS 2.6.4 CONDUIT2.6.6 POWER SUPPLY CORD 2.6.5 ISOLATING DIFFERENT POWER SOURCESFigure 2.14 - Transfer Switch Isolation Method 2.7 BATTERY INSTALLATION 2.8 OPTIONAL ACCESSORIES2.7.1 RECOMMENDED BATTERY 2.7.2 BATTERY CABLES3.1 POST INSTALLATION TESTS 3.4 TESTING UNDER LOADDo not make any unnecessary adjustments 3.2 BEFORE INITIAL START-UP3.5 INSTALLATION CHECKLIST Appendix 1 - Notes 34 Generac Power Systems, IncTROUBLESHOOTING GUIDE PROBLEMCAUSE CORRECTION36 Generac Power Systems, Inc Appendix 3 - Electrical DataBROWN Data PowerQUIETPACT Appendix 3 - Electrical38 Generac Power Systems, Inc Appendix 4 - Exploded Views and Parts ListsEnclosure - Drawing No. 0D8352-E TO CARBPART NO. QTY Appendix 4 - Exploded Views and Parts ListsDESCRIPTION 40 Generac Power Systems, Inc Appendix 4 - Exploded Views and Parts Lists 42 Generac Power Systems, Inc 25 24Appendix 4 - Exploded Views and Parts Lists 44 Generac Power Systems, Inc ASSEMBLY BRACKET GOVERNOR BOOT CHOKE SOLENOID PLASTICASSEMBLY, GOVERNOR LEVER GASKET CARBURETOR/MANIFOLD46 Generac Power Systems, Inc TAPERED CRANKSHAFT ASSEMBLY SCREW, HHFC M8-1.25 X 35MMVALVE SPRING WEAR WASHER OIL PRESSURE RELIEF COVERCALIFORNIA AND FEDERAL EMISSION CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONSMANUFACTURER’S EMISSION CONTROL SYSTEM WARRANTY COVERAGE PURCHASER’S/OWNER’S WARRANTY RESPONSIBILITIESEMISSION CONTROL SYSTEM WARRANTY EMISSION RELATED PARTS INCLUDE THE FOLLOWING1 Utility 2 Lawn and Garden Equipment 3 Recreational Vehicle RV Generator 4 Industrial Mobile IM GeneratorGENERAC POWER SYSTEMS’ THREE-YEAR LIMITED WARRANTY WARRANTY SCHEDULE - COMMERCIAL APPLICATIONSWARRANTY SCHEDULE - CONSUMER/PERSONAL APPLICATIONS GENERAC POWER SYSTEMS, INC