Subaru Robin Power Products R1200 Pull out the intake valve and the exhaust valve, Retainer

1 Part to 1

Sequence.remOve !

28IIgnition I (1) 1plug

29/ Cylinder j(1) ,head

I

1

I(2)

I

Description		I	Precautions	Necessary
				tools
Remove the ignition	plug	1		!21 m/m box
from the cylinder head.		I		ispanner
Remove the cylinder	head			!12 m/m box
from the crankcase by				ispanner
taking out the eight	M8 x	!		1
40 flange bolts.

I

Remove the cylinder head II gasket from the crankcase. ,

30/Intake/ i (1)

1exhaust ,

lvalve	,
I	!
)
	! (2)
I
	I
	, (3)
I	I
	1

31 1Main bear- / (1) Iing cover !

I1

I

i (2)

I;

Remove the tappet cover and the breather plate from the crankcase by taking taking out the two M6 x 12 flange bolts.

Pull out the intake valve and the exhaust valve.

Remove the valve spring and the spring retainer.

Remove the main bearing cover locking bolts (eight M6 x 30 bolts) from the crank case.

Remove the cover by tap- ping it evenly with a plastic hammer.

I Be sure to position	i 10 m/m box
/ the notch in the	:spanner
1spring retainer’s	’
outside periphery to
[ the front and hook	i
’ the minus driver
j (medium sizej in the ;
, recess (lower side)	:	i
i of the retainer.	!	Front
Then pull the spring	[	0 Driver
I retainer frontward	i
j to remove the valve. n
Washerbuilt-in bolt.		10 m/m box
	,spanner

II

1

! Be careful not to

I damage the oil seal.

lntak Valve, , Exhaust Valve , M8x40 Flange Bolt (8 PCS.)

/ Muffler

Flange Bolt (2 PCS.)

M6x30 Bolt (8 PCS.) Fig. 9-3-24 Tappet Cover