Carrier 69UG15 manual Auto RE-START Option

		REMEDY/
CONDITION	POSSIBLE CAUSE	REFERENCE
		SECTION
3.3 ALTERNATING CURRENT GENERATOR (CONTINUED)
	Generator overloaded	Check
	Clogged ventilating screens	Clean
	High temperature surrounding generator	Section 4.4.5
Overheating	Insufficient air circulation	Section 4.5.1
	Unbalanced load	Balance
	Dry bearing	Section 4.5.1/
		4.5.3
	Bad bearing	Section 4.5.1/
		4.5.3
	Rotor scrubbing on stator	Section 4.5.1/
Mechanical Noise	Loose laminations	4.5.3
		Section 4.5.4/
		Replace
	Loose or misaligned coupling	Section 4.5.4
	Static charge	Check ground to
Generator frame produces shock		frame
when touched	Grounded armature of field coil	Section 4.5.4/
		Replace
3.4 AUTO RE-START OPTION
	Wait 30 seconds for intake heater to be activated	Wait
	Coolant level below the low coolant sensor	1.10.j.
	Relay defective	Check/Replace
	Ignition switch defective	Check/Replace
		Switch
When the Ignition switch is placed in	3 amp Fuse is bad	Check and
the RUN position, nothing happens--		Replace Fuse
no lights illuminate	Loose connector on module	Tighten
		connector
	Auto restart module is bad	Check for 12
		volts at Pin 4/
		Replace module
	Miswired connectors	Check/Correct
		wiring
Alarm sounds, but engine does not	No voltage at Pin 2 of the connector	Trace/Correct
	Check Starter Solenoid	See 3.1.1
crank
	Auto restart module is bad	Replace module
Engine starts, but the starter does	Speed Sensor wiring loose	Check/Correct
	Speed Sensor is bad	Replace
not disengage
	Auto restart module is bad	Replace module

3--5 T-343