Servis-Rhino RC-12 manual Safety

Page 27

SAFETY

INFORMATION - Operator’s Manual Inside

P/N 00776481

WARNING! Do not operate with Belt Shield removed. Finger(s) may be pinched off if caught between V-Belt and Pulley.

P/N 00758194

Instructions for operation and maintenance of Flail Shredders.

P/N 00725747

Instructions for filling Gearbox with oil.

P/N 00725738

RC12 12-05

Safety Section 1-23

© 2005 Alamo Group Inc.

SAFETY

Image 27
Contents RC-12 To the Owner/Operator/Dealer Warranty InformationTable of Contents Maintenance Section Safety Section Safety Wait a minute...Save a life Safety Equipment Operation Safety Instructions and Practices Stop Mowing if Passersby are Within 100 Yards Unless Safety Safety RC12 Safety Section STI-3 Safety MPH. STI-6 Maintenance and Service Safety Instructions and Practices Parts Information Concluding Safety Instructions and Practices Peligro ReflectInstruct Model NFS SER PLTLogo NameDecal Description Has stopped. P/N RC12 Safety Section Safety Safety Safety Safety Safety Safety Federal Laws and Regulations Introduction Section Introduction Before Operating this Machine Owners Responsibilities Safety Instructions Page Assembly Section Breather Plug Installation Tongue Assembly InstallationShipping Stand Removal Assembly Asm-FL-0066 Point Hitch Assembly Installation Attaching Optional Hydraulic Cylinder Attaching Axle Assemblies to Main Wheel BAR TubeOperation Section Operation CAT II-III Q.H OperationPersonal Protective Equipment PPE Operator RequirementsTractor Safety Devices Tractor Requirements and CapabilitiesRops and Seat Belt Drawbar-Pull Type Mower Front End WeightPower Take Off PTO 3-Point HitchBoarding the Tractor Getting on and OFF the TractorDismounting the Tractor Starting the Tractor Connecting the Mower to the TractorSemi-Mount Models Setting the MowerPull Type Models Lift Type ModelsOperation Leveling Deck Driveline AttachmentDriveline Clearance PRE-OPERATION Inspection and Service Engagement Check ProcedureShorten the driveline profiles as follows Mower Pre-Operation Inspection/Service Tractor Pre-Operation Inspection/ServiceSGM-10 Operation Driving the Tractor and Implement Starting the Tractor Raising the Mower Brake and Differential Lock SettingDriving the Tractor and Mower Turning ProcedureCrossing Ditches and Steep Inclines Operating the Tractor and Implement Operation Foreign Debris Hazards Bystanders/Passersby PrecautionsEngaging the Power Take Off PTO Operating the Mower PTO RPM and Ground SpeedOperation Shutting Down the Implement OPS-F-0012A Disconnecting the Mower from the TractorTransporting the Tractor and Implement Mower StorageOperation Transporting on Public Roadways OPS-U Hauling the Tractor and Implement Problem Possible Cause Remedy Trouble Shooting GuidePTO RPM Page Maintenance Section Lubrication General MaintenanceRoutine Maintenance Blade Replacement Belt Adjustment and ReplacementCutter Shaft Pulley Alignment and Removal Maintenance Outer Cutter Shaft Bearing Removal InstallationCutter Shaft and Bearing Removal Cutter Shaft Bearing Removal Mnt-FL-0041Cutter Shaft Removal TOP Drive Assembly ServicingDriveline Shield Replacement DrivelineMnt-FL-0032 Figure Mnt-FL-0036 Pre-season Check Storing the RC12Rhino Required of the Operator Required of the OwnerRC12 12/05 00726339C Printed U.S.A