MAINTENANCE
STORING THE RC12
•When storing the RC12 for an extended period of time, or at the end of a season, lubricate all bearings with enough grease to eliminate any cavities where water condensation may occur and cause damage. Refer to "Lubrication" for location of all grease fitting. Be sure the vent on top of the Gearbox is open.
NOTE: IMPORTANT - Use a hand grease gun. Do not
•Loosen the Set Nut and Spindle Jack to relieve drive belt tension.
NOTE: Before next season's use be sure to adjust the drive belt tension.
•Coat all exposed surfaces inside the mower with oil or grease to prevent rusting and pitting during storage.
Pre-season Check
1.Check the oil level in the Gearbox and lubricate all bearings. See "Lubrication".
2.Adjust drive belt tension. See "Belt Drive".
3.Inspect for missing and / or broken Blades / Knives. Replace as necessary. See "Knife Replacement".
4.Be sure that the Safety Guard is in place and secure.
5.Run the Orchard at a low RPM checking to make sure that all driveline parts are moving freely.
RC12 12/05 | Maintenance Section |
© 2004 Alamo Group Inc.